DataSheet.es    


PDF SGM3141 Data sheet ( Hoja de datos )

Número de pieza SGM3141
Descripción 700mA Buck/Boost Charge Pump LED Driver
Fabricantes Shengbang Microelectronics 
Logotipo Shengbang Microelectronics Logotipo



Hay una vista previa y un enlace de descarga de SGM3141 (archivo pdf) en la parte inferior de esta página.


Total 14 Páginas

No Preview Available ! SGM3141 Hoja de datos, Descripción, Manual

SGM3141
700mA Buck/Boost
Charge Pump LED Driver
GENERAL DESCRIPTION
FEATURES
The SGM3141 is a current-regulated charge pump ideal
for powering high brightness LEDs for camera flash
applications. The charge pump can be set to regulate two
current levels for Flash and Torch modes.
The SGM3141 automatically switches modes between
step-up and step-down ensuring that LED current does
not depend on the forward voltage. It switches at 2.2MHz,
allowing the use of tiny components. The supply voltage
ranges from 2.7V to 5.5V and is ideally suited for all
applications powered by a single Li-ion battery cell or
three to four NiCd, NiMH, or Alkaline battery cells.
The SGM3141 also features a very low shutdown current,
an automatic soft-start mode to limit inrush current, as
well as over-current, over-voltage and over-temperature
thermal shutdown control.
A low current-sense reference voltage (47mV) allows the
use of small 0603 current sensing resistors.
The SGM3141 is available in Green TDFN-3×3-10L
package and is specified over an ambient temperature
range of -40to +85.
APPLICATIONS
White LED Torch, Flash for Cell
Phones, DSCs and Camcorders
White LED Backlighting
Generic Lighting, Flash and Strobe Applications
General Purpose High Current Boost
Output Current Up to 700mA
Up to 90% Efficiency in Torch Mode
Adjustable Flash Mode Current
1× and 2× Automatic Modes for High Efficiency
Input Voltage Range: 2.7V to 5.5V
Minimum External Components: No Inductors
High Frequency Operation: 2.2MHz
Low 47mV Reference for Low Loss Sensing
IQ < 1μA in Shutdown
Built-In Soft-Start Limits Inrush Current
Low Input and Output Ripple and Low EMI
Output Over-Voltage Protection
Over-Current and Over-Temperature Protection
Available in Green TDFN-3×3-10L Package
TYPICAL APPLICATION
VIN
2.7V to 5.5V
CIN
4.7μF
CF
1μF
TORCH/FLASH
ENABLE
1
VIN
VOUT 10
2 C1
9
PGND
SGM3141
3
C2
8
SGND
4
FLASH
7
FB
COUT
1μF
5 EN
6
RSET
RSET
86.6kΩ
WLED
RSENSE
0.22Ω
SG Micro Corp
www.sg-micro.com
REV. A. 3

1 page




SGM3141 pdf
SGM3141
700mA Buck/Boost
Charge Pump LED Driver
TYPICAL PERFORMANCE CHARACTERISTICS
CIN = 10μF, COUT = 4.7μF, CF = 1μF, unless otherwise noted.
SG Micro Corp
www.sg-micro.com
5

5 Page





SGM3141 arduino
SGM3141
EVALUATION BOARD LAYOUT
700mA Buck/Boost
Charge Pump LED Driver
Printed Circuit Board Layout Recommendations
Follow the PCB layout guidelines for optimal performance:
1. Place the flying capacitor CF as close to the chip as possible; otherwise 2× mode performance will be compromised.
Also keep analog components away from this capacitor.
2. Place input and output decoupling capacitors as close to the chip as possible to reduce switching noise and output
ripple.
3. The power traces, consisting of the VIN/GND trace, the VOUT trace and the WLED trace should be kept short and
wide. Also minimize the feedback loop area (consisting of WLED/FB) small.
4. Connect the exposed pad to the GND plane to achieve the best power dissipation.
SG Micro Corp
www.sg-micro.com
11

11 Page







PáginasTotal 14 Páginas
PDF Descargar[ Datasheet SGM3141.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
SGM3140500mA Buck/Boost Charge Pump LED DriverShengbang Microelectronics
Shengbang Microelectronics
SGM3140B500mA Buck/Boost Charge Pump LED DriverShengbang Microelectronics
Shengbang Microelectronics
SGM3141700mA Buck/Boost Charge Pump LED DriverShengbang Microelectronics
Shengbang Microelectronics
SGM3141B700mA Buck/Boost Charge Pump LED DriverShengbang Microelectronics
Shengbang Microelectronics

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar