DataSheet.es    


PDF BU21049GUL Data sheet ( Hoja de datos )

Número de pieza BU21049GUL
Descripción 4-wire Resistive Touch Screen Controller
Fabricantes ROHM Semiconductor 
Logotipo ROHM Semiconductor Logotipo



Hay una vista previa y un enlace de descarga de BU21049GUL (archivo pdf) en la parte inferior de esta página.


Total 26 Páginas

No Preview Available ! BU21049GUL Hoja de datos, Descripción, Manual

BU21049GUL
4-wire Resistive
Touch Screen Controller
BU21049GUL
General Description
Unlike most resistive touch screen controllers, the
BU21049GUL 4-wire resistive touch-screen controller
generate data to enable dual touch detection.
The Host processor can use data to detect single point
coordinates and dual coordinates.
Features
Enables single touch and dual touch using
standard 4-wire resistive touch screen
I2C like interface for interfacing to the host
processor
12-bit Resolution
Single 1.65V to 3.60V Supply.
Power on reset
Auto power down control
Built-in clock oscillation circuit
Typical Application Circuits
Key Specifications
Power supply voltage
Temperature range
Standby current
Sleep current
Operating current
Coordinate resolution
1.65V3.6.0V
-20[]85[]
1.0uA (Max.)
100uA (Typ.)
0.8mA(Typ.)
12bit
Packages
VCSP50L2
2.00 × 2.00 × 0.55(max)
Applications
Equipment with a built in the user interface of 4-wire
resistive touch screen
Portable information equipment like as Smart phone,
Table, PDA.
Audio-visual equipment like as Digital still camera,
Digital video camera, portable TV.
PC/ PC peripheral equipment like as Laptop, Touch
screen monitor, printer.
Product structureSilicon monolithic integrated circuit
.www.rohm.co
© 2011 ROHM Co., Ltd. All rights reserved.
TSZ2211114001
This product is not designed protection against radioactive rays
1/23
TSZ02201-0Y1Y0F300010-1-2
31.JAN.2012 Rev.001

1 page




BU21049GUL pdf
BU21049GUL
Host interface AC timing
The slave address for 2-wire serial interface is selectable from “40h” or “41h” by “AD0” input.
AD0 = “L” : Slave Address = 40h
AD0 = “H” : Slave Address = 41h
.
Datasheet
2-wire serial I/F AC timing characteristics (Ta=25, VDD=PVDD=3.00V, GND=0.00V, unless otherwise noted)
Parameter
Symbol
MIN
Rating
TYP
MAX
Unit
Condition
SCL clock frequency
fSCL
0
- 400 kHz
START condition hold time
tHD:STA
0.6
-
- us
SCL “L” period
tLOW
1.3
-
- us
SCL “H” period
tHIGH
0.6
-
- us
Data hold time
tHD:DAT
0.0
-
- us
Data setup time
tSU:DAT
0.1
-
- us
STOP condition setup time
tSU:STO
0.6
-
- us
www.rohm.co
© 2011 ROHM Co., Ltd. All rights reserved.
TSZ2211115001
5/23
TSZ02201-0Y1Y0F300010-1-2
31.JAN.2012 Rev.001

5 Page





BU21049GUL arduino
BU21049GUL
Datasheet
Specification of touch detection
The BU21049GUL builds in the touch detection function for outputting the interrupt signal to the INT pin during detect touch.
The equivalent circuit schematic of a touch detection function is shown in the following figure.
PVDD
INT
Short when touch
screen is touched
YP
50kΩ
90kΩ
PU90K
(register)
XP
High when XP or YP
dirvers ON
YN
ON
PGND
GND
Control
Logic
When the touch panel is connected to the panel interface terminal (XP, XN, YP, YN), XP pin is connected to PVDD through
internal pull-up resistance inside IC, the YN pin connects with PGND, and the BU21049GUL will be in a standby state at the
no-touch. At this time, the INT pin outputs "H" by an internal pull-up.
Since the XP pin and the YN pin are connected through the contact resistance of a touch screen when a touch screen is
touched, the resistance ratio of internal pull-up resistance and touch screen resistance detects the voltage drop of the XP
pin, and it outputs "L" from the INT pin.
Moreover, when a touch is detected and the XP pin or the YP pin changes into a drive state by each scanning operation,
internal pull-up resistance is separated from the XP pin, and the "L" output of the INT pin is held.
www.rohm.co
© 2011 ROHM Co., Ltd. All rights reserved.
TSZ2211115001
11/23
TSZ02201-0Y1Y0F300010-1-2
31.JAN.2012 Rev.001

11 Page







PáginasTotal 26 Páginas
PDF Descargar[ Datasheet BU21049GUL.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
BU21049GUL4-wire Resistive Touch Screen ControllerROHM Semiconductor
ROHM Semiconductor

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar