|
|
Número de pieza | LS013B4DN01 | |
Descripción | LCD Module | |
Fabricantes | Sharp | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de LS013B4DN01 (archivo pdf) en la parte inferior de esta página. Total 29 Páginas | ||
No Preview Available ! Technical Document
LCD Specification
LCD Group
LS013B4DN01 LCD Module
Preliminary Product Specification
April 2009
96 × 96 Silver Reflective PNLC Memory LCD
Module featuring Zebra (elastomeric) connector,
50% reflectivity with 10:1 contrast.
1 page SPEC No.
MODEL No.
LCY-12T09302A
LS013B4DN01
PAGE
3
[For operating LCD module]
(1) Do not operate the LCD panel under outside of electrical specification. Otherwise LCD panel may be damaged.
(2) Do not operate the LCD panel under outside of specified driving timing chart. Otherwise LCD panel may not have proper
picture quality.
(3) A still image should be displayed less than two hours, if it is necessary to display still image longer than two hour, display
image data must be refreshed in order to avoid sticking image on LCD panel.
[Precautions for Storage]
(1) Do not expose the LCD module to direct sunlight or strong ultraviolet light for long periods. Store in a dark place.
(2) The liquid crystal material will solidify if stored below the rated storage temperature and will become an isotropic liquid if
stored above the rated storage temperature, and may not retain its original properties. Only store the module at normal
temperature and humidity (25±5°C,60±10%RH) in order to avoid exposing the UV protection film to chronic humidity.
(3) Keeping Method
a. Don't keeping under the direct sunlight.
b. Keeping in the tray under the dark place.
5 Page SPEC No.
MODEL No.
LCY-12T09302A
LS013B4DN01
PAGE
9
6-2)Power supply sequence
[On sequence] * All on start up System
①5V start up
②Initializes memory data within pixel
T2 : more than 1V
Initialize with D2 "all clear flag" or display all white.
③To cancel latch initialization for TCOM.
T3 : more than 30us
The period of canceling COM latch circuit for initialization by using DISP signal.
④TCOM polarity initialization
T4: more than 30us
The period of initialization for TCOM polarity by EXTCOMIN signal.
[Normal operation]
Duration of normal driving.
[Off sequence]
⑤Initializes memory data within pixel
⑥The period of initialization for VA, VB, and VCOM
⑦5V shut down
T5 : more than 1V
T6 : more than 1V
On Sequence
Normal operation
Off Sequence
VDD/VDDA (5V)
DISP
EXTCOMIN
SCS
Others
① ② ③※1 ④※1
T1 T2 T3 T4
GND
GND
GND
GND ※2
GND ※2
Normal operation
Normal operation
Normal operation
⑤⑥⑦
T5 T6 T7
GND
GND
GND
※2 GND
※2 GND
※Detail description for signal timing is shown the digital timing chart and the AC timing chart.
※1 The order of ③ and ④ can be set as being reversed, in this case, TCOM polarity inversion timing which can be controlled
by EXTCOMIN doesn't work during DISP="L".
※2 Setup value for initialization of data within pixel memory
To refer the timing chart of all clear mode section 6-5-4.
[Remark] Precaustions at ehte time of power on and power off.
Remark 1)When power on , VDDand VDDA are same timem or VDD should be faster than the VDDA.
Remark 2) When power off, VDD and VDDA are same time or VDDA shoud be faster than the VDD.
11 Page |
Páginas | Total 29 Páginas | |
PDF Descargar | [ Datasheet LS013B4DN01.PDF ] |
Número de pieza | Descripción | Fabricantes |
LS013B4DN01 | LCD Module | Sharp |
LS013B4DN02 | TFT-LCD Module | Sharp |
LS013B4DN04 | LCD Module | Sharp |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |