DataSheetWiki


6N139 fiches techniques PDF

Vishay - High Speed Optocoupler

Numéro de référence 6N139
Description High Speed Optocoupler
Fabricant Vishay 
Logo Vishay 





1 Page

No Preview Available !





6N139 fiche technique
www.vishay.com
6N138, 6N139
Vishay Semiconductors
High Speed Optocoupler, 100 kBd, Low Input Current,
Photodiode Darlington Output
NC 1
A2
C3
NC 4
8 VCC
7 VB
6 VO
5 GND
FEATURES
• High current transfer ratio, 300 %
• Low input current, 0.5 mA
• High output current, 60 mA
• Isolation test voltage, 5300 VRMS
• TTL compatible output, VOL = 0.1 V
• High common mode rejection, 500 V/μs
• Adjustable bandwidth-access to base
• Material categorization: for definitions of compliance
please see www.vishay.com/doc?99912
DESCRIPTION
High common mode transient immunity and very high
current ratio together with 5300 VRMS insulation are
achieved by coupling and LED with an integrated high gain
photo detector in an eight pin dual-in-line package.
Separate pins for the photo diode and output stage enable
TTL compatible saturation voltages with high speed
operation.
Access to the base terminal allows adjustment to the gain
bandwidth.
The 6N138 is ideal for TTL applications since the 300 %
minimum current transfer ratio with an LED current of
1.6 mA enables operation with one unit load-in and one unit
load-out with a 2.2 kΩ pull-up resistor.
The 6N139 is best suited for low power logic applications
involving CMOS and low power TTL. A 400 % current
transfer ratio with only 0.5 mA of LED current is guaranteed
from 0 °C to 70 °C.
Caution: Due to the small geometries of this device, it should be
handled with Electrostatic Discharge (ESD) precautions. Proper
grounding would prevent damage further and/or degradation which
may be induced by ESD.
APPLICATIONS
• Microprocessor system interface
• PLC, ATE input / output isolation
• EIA RS232 line receiver
• TTL, CMOS voltage level translation
• Multiplexed data transmission
• Digital control power supply
• Ground loop and electrical noise elimination
AGENCY APPROVALS
• UL1577, file no. E52744, double protection
• DIN EN 60747-5-5 available with option 1
ORDERING INFORMATION
6N13# - X0##T
DIP
PART NUMBER
PACKAGE OPTION
TAPE
AND
REEL
7.62 mm
Option 7
Option 9
AGENCY CERTIFIED/PACKAGE
CTR (%)
1.6 mA
> 0.7 mm
> 0.1 mm
UL
DIP-8
SMD-8, option 7
SMD-8, option 9
VDE
SMD-8, option 7
SMD-8, option 9
> 300
6N138
6N138-X007T
6N138-X009T
> 300
-
-
> 500
6N139, 6N139-X001
6N139-X007, 6N139-X007T
6N139-X009, 6N139-X009T
> 500
6N139-X017T
6N139-X019T
Note
• For additional information on the available options refer to option information.
Rev. 1.6, 23-Jan-15
1 Document Number: 83605
For technical questions, contact: [email protected]
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000

PagesPages 9
Télécharger [ 6N139 ]


Fiche technique recommandé

No Description détaillée Fabricant
6N134 Hermetically Sealed / High Speed / High CMR / Logic Gate Optocouplers Hewlett-Packard
Hewlett-Packard
6N135 High Speed Optocouplers LITE-ON
LITE-ON
6N135 High Speed Optocoupler Vishay
Vishay
6N135 IRED & PHOTO IC (DIGITAL LOGIC ISOLATION) Toshiba Semiconductor
Toshiba Semiconductor

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche