|
|
PDF AT89C5131 Data sheet ( Hoja de datos )
| Número de pieza | AT89C5131 | |
| Descripción | 8-bit Flash Microcontroller | |
| Fabricantes | ATMEL Corporation | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de AT89C5131 (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
|
No Preview Available !
Features
• 80C52X2 Core (6 Clocks per Instruction)
– Maximum Core Frequency 48 MHz in X1 Mode, 24MHz in X2 Mode
– Dual Data Pointer
– Full-duplex Enhanced UART (EUART)
– Three 16-bit Timer/Counters: T0, T1 and T2
– 256 Bytes of Scratchpad RAM
• 32-Kbyte On-chip Flash In-System Programming through USB or UART
• 4-Kbyte EEPROM for Boot (3-Kbyte) and Data (1-Kbyte)
• On-chip Expanded RAM (ERAM): 1024 Bytes
• USB 1.1 and 2.0 Full Speed Compliant Module with Interrupt on Transfer Completion
– Endpoint 0 for Control Transfers: 32-byte FIFO
– 6 Programmable Endpoints with In or Out Directions and with Bulk, Interrupt or
Isochronous Transfers
• Endpoint 1, 2, 3: 32-byte FIFO
• Endpoint 4, 5: 2 x 64-byte FIFO with Double Buffering (Ping-pong Mode)
• Endpoint 6: 2 x 512-byte FIFO with Double Buffering (Ping-pong Mode)
– Suspend/Resume Interrupts
– Power-on Reset and USB Bus Reset
– 48 MHz DPLL for Full-speed Bus Operation
– USB Bus Disconnection on Microcontroller Request
• 5 Channels Programmable Counter Array (PCA) with 16-bit Counter, High-speed
Output, Compare/Capture, PWM and Watchdog Timer Capabilities
• Programmable Hardware Watchdog Timer (One-time Enabled with Reset-out): 50 ms to
6s at 4 MHz
• Keyboard Interrupt Interface on Port P1 (8 Bits)
• TWI (Two Wire Interface) 400Kbit/s
• SPI Interface (Master/Slave Mode)
• 34 I/O Pins
• 4 Direct-drive LED Outputs with Programmable Current Sources: 2-6-10 mA Typical
• 4-level Priority Interrupt System (11 sources)
• Idle and Power-down Modes
• 0 to 32 MHz On-chip Oscillator with Analog PLL for 48 MHz Synthesis
• Low Power Voltage Range
– 3.0V to 3.6V
– 30 mA Max Operating Current (at 40 MHz)
– 100 µA Max Power-down Current
• Industrial Temperature Range
• Packages: PLCC52, VQFP64, MLF48, SO28
8-bit Flash
Microcontroller
with Full Speed
USB Device
AT89C5131
Rev. 4136C–USB–04/05
1 page  
Figure 2. AT89C5131 64-pin VQFP Pinout
AT89C5131
64 63 62 61 60 59 58 57 56 55 54 53 52 51 50 49
NC 1
P2.3/A11 2
P2.4/A12 3
P2.5/A13 4
XTAL2
XTAL1
P2.6/A14
5
6
7
P2.7/A15 8
VDD 9
AVDD 10
NC 11
AVSS 12
NC 13
P3.0/RxD 14
NC 15
NC 16
VQFP64
48 NC
47 NC
46 P0.1/AD1
45 P0.2/AD2
44 RST
43 P0.3/AD3
42 VSS
41 NC
40 P0.4/AD4
39 P3.7/RD/LED3
38 P0.5/AD5
37 P0.6/AD6
36 P0.7/AD7
35 P3.6/WR/LED2
34 NC
33 NC
17 18 19 20 21 22 23 24 25 26 27 28 29 30 3132
4136C–USB–04/05
5
5 Page 
AT89C5131
Table 12. Power Signal Description (Continued)
Signal
Name Type Description
VREF
USB pull-up Controlled Output
O VREF is used to control the USB D+ 1.5 kΩ pull up.
The Vref output is in high impedance when the bit DETACH is set in the
USBCON register.
Alternate
Function
-
4136C–USB–04/05
11
11 Page | ||
| Páginas | Total 30 Páginas | |
| PDF Descargar | [ Datasheet AT89C5131.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| AT89C5130A-M | 8-bit Flash Microcontroller | ATMEL Corporation |
| AT89C5131 | 8-bit Flash Microcontroller | ATMEL Corporation |
| AT89C5131A | USB Microcontrollers | ATMEL Corporation |
| AT89C5131A-L | 8-bit Flash Microcontroller | ATMEL Corporation |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |