AT90S2323 Datasheet PDF - ATMEL Corporation
| Part Number | AT90S2323 | |
| Description | 8-Bit Microcontroller with 2K Bytes of In-System Programmable Flash | |
| Manufacturers | ATMEL Corporation | |
| Logo |  |
|
|
There is a preview and AT90S2323 download ( pdf file ) link at the bottom of this page. Total 64 Pages | ||
Preview 1 page No Preview Available !
Features
• Utilizes the AVR® RISC Architecture
• AVR – High-performance and Low-power RISC Architecture
– 118 Powerful Instructions – Most Single Clock Cycle Execution
– 32 x 8 General-purpose Working Registers
– Up to 10 MIPS Throughput at 10 MHz
• Data and Nonvolatile Program Memory
– 2K Bytes of In-System Programmable Flash
Endurance: 1,000 Write/Erase Cycles
– 128 Bytes Internal RAM
– 128 Bytes of In-System Programmable EEPROM
Endurance: 100,000 Write/Erase Cycles
– Programming Lock for Flash Program and EEPROM Data Security
• Peripheral Features
www.DataShee–t4UO.ncoem8-bit Timer/Counter with Separate Prescaler
– Programmable Watchdog Timer with On-chip Oscillator
– SPI Serial Interface for In-System Programming
• Special Microcontroller Features
– Low-power Idle and Power-down Modes
– External and Internal Interrupt Sources
– Power-on Reset Circuit
– Selectable On-chip RC Oscillator
• Specifications
– Low-power, High-speed CMOS Process Technology
– Fully Static Operation
• Power Consumption at 4 MHz, 3V, 25°C
– Active: 2.4 mA
– Idle Mode: 0.5 mA
– Power-down Mode: <1 µA
• I/O and Packages
– Three Programmable I/O Lines for AT90S/LS2323
– Five Programmable I/O Lines for AT90S/LS2343
– 8-pin PDIP and SOIC
• Operating Voltages
– 4.0 - 6.0V for AT90S2323/AT90S2343
– 2.7 - 6.0V for AT90LS2323/AT90LS2343
• Speed Grades
– 0 - 10 MHz for AT90S2323/AT90S2343-10
– 0 - 4 MHz for AT90LS2323/AT90LS2343-4
– 0 - 1 MHz for AT90LS2343-1
8-bit
Microcontroller
with 2K Bytes of
In-System
Programmable
Flash
AT90S2323
AT90LS2323
AT90S2343
AT90LS2343
Pin Configuration
PDIP/SOIC
RESET
(CLOCK) PB3
PB4
GND
1
2
3
4
8 VCC
RESET 1
7 PB2 (SCK/T0)
XTAL1 2
6 PB1 (MISO/INT0) XTAL2 3
5 PB0 (MOSI)
GND 4
8 VCC
7 PB2 (SCK/T0)
6 PB1 (MISO/INT0)
5 PB0 (MOSI)
AT90S/LS2343
AT90S/LS2323
Rev. 1004D–09/01
1
|
| |
 
Pin Descriptions
AT90S/LS2343
VCC
GND
Port B (PB4..PB0)
www.DataSheet4U.com
RESET
CLOCK
Clock Options
Crystal Oscillator
AT90S/LS2323/2343
Supply voltage pin.
Ground pin.
Port B is a 5-bit bi-directional I/O port with internal pull-up resistors. The Port B output
buffers can sink 20 mA. As inputs, Port B pins that are externally pulled low, will source
current if the pull-up resistors are activated.
Port B also serves the functions of various special features.
Port pins can provide internal pull-up resistors (selected for each bit). The Port B pins
are tri-stated when a reset condition becomes active.
Reset input. An external reset is generated by a low level on the RESET pin. Reset
pulses longer than 50 ns will generate a reset, even if the clock is not running. Shorter
pulses are not guaranteed to generate a reset.
Clock signal input in external clock mode.
The AT90S/LS2323 contains an inverting amplifier that can be configured for use as an
On-chip oscillator, as shown in Figure 3. XTAL1 and XTAL2 are input and output
respectively. Either a quartz crystal or a ceramic resonator may be used. It is recom-
mended that the AT90S/LS2343 be used if an external clock source is used, since this
gives an extra I/O pin.
Figure 3. Oscillator Connection
External Clock
1004D–09/01
The AT90S/LS2343 can be clocked by an external clock signal, as shown in Figure 4, or
by the On-chip RC oscillator. This RC oscillator runs at a nominal frequency of 1 MHz
(VCC = 5V). A fuse bit (RCEN) in the Flash memory selects the On-chip RC oscillator as
the clock source when programmed (“0”). The AT90S/LS2343 is shipped with this bit
programmed. The AT90S/LS2343 is recommended if an external clock source is used,
because this gives an extra I/O pin.
The AT90S/LS2323 can be clocked by an external clock as well, as shown in Figure 4.
No fuse bit selects the clock source for AT90S/LS2323.
5
Preview 5 Page |
Part DetailsOn this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for AT90S2323 electronic component. |
| Information | Total 64 Pages | |
| Link URL | [ Copy URL to Clipboard ] | |
| Download | [ AT90S2323.PDF Datasheet ] | |
Share Link :
Electronic Components Distributor
|
An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists. |
| SparkFun Electronics | Allied Electronics | DigiKey Electronics | Arrow Electronics |
| Mouser Electronics | Adafruit | Newark | Chip One Stop |
Featured Datasheets
| Part Number | Description | MFRS |
| AT90S2323 | The function is 8-Bit Microcontroller with 2K Bytes of In-System Programmable Flash. ATMEL Corporation | |
| AT90S2323-10PC | The function is 8-Bit Microcontroller with 2K Bytes of In-System Programmable Flash. ATMEL Corporation | |
| AT90S2323-10PI | The function is 8-Bit Microcontroller with 2K Bytes of In-System Programmable Flash. ATMEL Corporation | |
Semiconductors commonly used in industry:
1N4148 |
BAW56 |
1N5400 |
NE555 | | ||
Quick jump to:
AT90
1N4
2N2
2SA
2SC
74H
BC
HCF
IRF
KA | ||