AT25040-10PI-1.8 Datasheet PDF - ATMEL Corporation
| Part Number | AT25040-10PI-1.8 | |
| Description | SPI Serial EEPROMs | |
| Manufacturers | ATMEL Corporation | |
| Logo |  |
|
|
There is a preview and AT25040-10PI-1.8 download ( pdf file ) link at the bottom of this page. Total 15 Pages | ||
Preview 1 page No Preview Available !
Features
• Serial Peripheral Interface (SPI) Compatible
• Supports SPI Modes 0(0,0) and 3(1,1)
• Low-Voltage and Standard-Voltage Operation
– 5.0 (VCC = 4.5V to 5.5V)
– 2.7 (VCC = 2.7V to 5.5V)
– 1.8 (VCC = 1.8V to 3.6V)
• 2.1 MHz Clock Rate (5V) Compatibility
• 8-Byte Page Mode
• Block Write Protection
– Protect 1/4, 1/2, or Entire Array
• Write Protect (WP) Pin and Write Disable Instructions for
Both Hardware and Software Data Protection
• Self-Timed Write Cycle (10 ms Max)
• High Reliability
– Endurance: 1 Million Write Cycles
– Data Retention: 100 Years
– ESD Protection: >4000V
• Automotive Grade and Extended Temperature Devices Available
• 8-Pin PDIP and JEDEC SOIC Packages
Description
The AT25010/020/040 provides 1024/2048/4096 bits of serial electrically erasable
programmable read only memory (EEPROM) organized as 128/256/512 words of 8
bits each. The device is optimized for use in many industrial and commercial applica-
tions where low power and low voltage operation are essential. The AT25010/020/040
is available in space saving 8-pin PDIP and 8-pin JEDEC (SOIC) packages.
The AT25010/020/040 is enabled through the Chip Select pin (CS) and accessed via
a 3-wire interface consisting of Serial Data Input (SI), Serial Data Output (SO), and
Serial Clock (SCK). All programming cycles are completely self-timed, and no sepa-
rate ERASE cycle is required before WRITE.
BLOCK WRITE protection is enabled by programming the status register with one of
four blocks of write protection. Separate program enable and program disable instruc-
tions are provided for additional data protection. Hardware data protection is provided
via the WP pin to protect against inadvertent write attempts. The HOLD pin may be
used to suspend any serial communication without resetting the serial sequence.
Pin Configurations
Pin Name
CS
SCK
SI
SO
GND
VCC
WP
HOLD
Function
Chip Select
Serial Data Clock
Serial Data Input
Serial Data Output
Ground
Power Supply
Write Protect
Suspends Serial Input
8-Pin PDIP
CS
SO
WP
GND
1
2
3
4
8 VCC
7 HOLD
6 SCK
5 SI
8-Pin SOIC
CS
SO
WP
GND
1
2
3
4
8 VCC
7 HOLD
6 SCK
5 SI
SPI Serial
EEPROMs
1K (128 x 8)
2K (256 x 8)
4K (512 x 8)
AT25010
AT25020
AT25040
SPI, 1K Serial
E2PROM
Rev. 0606E–08/98
1
|
| |
 
AT25010/020/040
AC Characteristics (Continued)
Applicable over recommended operating range from TA = -40°C to +85°C, VCC = As Specified,
CL = 1 TTL Gate and 100 pF (unless otherwise noted).
Symbol
Parameter
Voltage
Min Max
tLZ Hold to Output Low Z
4.5 - 5.5
2.7 - 5.5
1.8 - 3.6
0 100
0 100
0 100
tHZ Hold to Output High Z
4.5 - 5.5
2.7 - 5.5
1.8 - 3.6
100
100
100
tDIS Output Disable Time
4.5 - 5.5
2.7 - 5.5
1.8 - 3.6
250
500
1000
tWC Write Cycle Time
4.5 - 5.5
2.7 - 5.5
1.8 - 3.6
10
Endurance
5.0V, 25°C, Page Mode
Note: 1. This parameter is characterized and is not 100% tested.
1M
Units
ns
ns
ns
ms
Write Cycles
5
Preview 5 Page |
Part DetailsOn this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for AT25040-10PI-1.8 electronic component. |
| Information | Total 15 Pages | |
| Link URL | [ Copy URL to Clipboard ] | |
| Download | [ AT25040-10PI-1.8.PDF Datasheet ] | |
Share Link :
Electronic Components Distributor
|
An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists. |
| SparkFun Electronics | Allied Electronics | DigiKey Electronics | Arrow Electronics |
| Mouser Electronics | Adafruit | Newark | Chip One Stop |
Featured Datasheets
| Part Number | Description | MFRS |
| AT25040-10PI-1.8 | The function is SPI Serial EEPROMs. ATMEL Corporation | |
Semiconductors commonly used in industry:
1N4148 |
BAW56 |
1N5400 |
NE555 | | ||
Quick jump to:
AT25
1N4
2N2
2SA
2SC
74H
BC
HCF
IRF
KA | ||