DataSheetWiki


3054 fiches techniques PDF

Allegro MicroSystems - MULTIPLEXED TWO-WIRE HALL-EFFECT SENSOR ICs

Numéro de référence 3054
Description MULTIPLEXED TWO-WIRE HALL-EFFECT SENSOR ICs
Fabricant Allegro MicroSystems 
Logo Allegro MicroSystems 





1 Page

No Preview Available !





3054 fiche technique
3054
MULTIPLEXED
TWO-WIRE
3054
HALL-EFFECT SENSOR ICs
LOGIC
12
3
Dwg. PH-005
Pinning is shown viewed from branded side.
ABSOLUTE MAXIMUM RATINGS
at TA = +25°C
Supply Voltage, VBUS . . . . . . . . . . . . . . 18 V
Magnetic Flux Density, B . . . . . . . Unlimited
Operating Temperature Range, TA
A3054KU . . . . . . . . . . . -40°C to +125°C
A3054SU . . . . . . . . . . . . -20°C to +85°C
Storage Temperature Range,
TS . . . . . . . . . . . . . . . . . -55°C to +150°C
Package Power Dissipation,
PD . . . . . . . . . . . . . . . . . . . . . . . 635 mW
MULTIPLEXED TWO-WIRE
HALL-EFFECT SENSOR ICs
The A3054KU and A3054SU Hall-effect sensors are digital mag-
netic sensing ICs capable of communicating over a two-wire power/
signal bus. Using a sequential addressing scheme, the device re-
sponds to a signal on the bus and returns the diagnostic status of the
IC, as well as the status of each monitored external magnetic field.
As many as 30 sensors can function on the same two-wire bus. This
IC is ideal for multiple sensor applications where minimizing the wiring
harness size is desirable or essential.
Each device consists of high-resolution bipolar Hall-effect switch-
ing circuitry, the output of which drives high-density CMOS logic
stages. The logic stages decode the address pulse and enable a
response at the appropriate address. The combination of magnetic-
field or switch-status sensing, low-noise amplification of the Hall-
transducer output, and high-density decoding and control logic is made
possible by the development of a new sensor DABiC™ (digital analog
bipolar CMOS) fabrication technology. The A3054SU is an improved
replacement for the original UGN3055U.
These unique magnetic sensing ICs are available in two tempera-
ture ranges; the A3054SU operates within specifications between
-20°C and +85°C, while the A3054KU is rated for operation between
-40°C and +125°C. Alternative magnetic and temperature specifica-
tions are available on special order. Both versions are supplied in
0.060" (1.54 mm) thick, three-pin plastic SIPs. Each device is clearly
marked with a two-digit device address (XX).
FEATURES
s Complete Multiplexed Hall-Effect ICs with
Simple Sequential Addressing Protocol
s Allows Power and Communication Over a
Two-Wire Bus (Supply/Signal and Ground)
s Up to 30 Hall-Effect Sensors Can Share a Bus
s Sensor Diagnostic Capabilities
s Magnetic-Field or Switch-Status Sensing
s Low Power of DABiC Technology Favors
Battery-Powered and Mobile Applications
s Ideal for Automotive, Consumer, and Industrial Applications
Always order by complete part number:
Part Number Operating Temperature Range
A3054KU-XX -40°C to +125°C
A3054SU-XX -20°C to +85°C
where XX = address (01, 02, … 29, 30).

PagesPages 12
Télécharger [ 3054 ]


Fiche technique recommandé

No Description détaillée Fabricant
3050PT Phase Control Thyristors nELL
nELL
3052-xxx PC BOard Mountable Accelerometer IC Sensors
IC Sensors
3052P SI-3052P Sanken electric
Sanken electric
3054 MULTIPLEXED TWO-WIRE HALL-EFFECT SENSOR ICs Allegro MicroSystems
Allegro MicroSystems

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche