DataSheetWiki


EX60T-CCV fiches techniques PDF

Hirose Electric - High-Speed Differential Signal Connectors

Numéro de référence EX60T-CCV
Description High-Speed Differential Signal Connectors
Fabricant Hirose Electric 
Logo Hirose Electric 





1 Page

No Preview Available !





EX60T-CCV fiche technique
NEW
High-Speed Differential Signal Connectors
EXT Series
1 Gbps Eye Pattern Waveform
(One End of Connector: 2 m of AWG #28 Twinax Cable)
sFeatures
01. High-Speed Differential Signals
The construction supports high-speed differential signals
such as LVDS, IEEE 1394, and USB 2.0. Use of twisted pair
cable or twinax cable permits transmission speeds up to
several hundred Mbps and higher per twisted pair.
(A) Impedance Matching
The connector is designed to minimize reflections with a
differential impedance of 100 ohms between adjacent contacts.
(B) Low Skew Construction
An equivalent electrical length is maintained between
adjacent contacts while the equivalent electrical length
between opposing terminals is approximately zero.
Consequently the skew within differential pairs as well as
between differential pairs is approximately zero.
However, a low skew between differential pairs is permitted
by going through another layer of the board.
(C) Low Crosstalk
The design features a staggered arrangement between
opposing contacts for low crosstalk effects between opposing
pairs even though these are low-profile connectors.
Differential impedance
between adjacent
contacts is 100 ohms
Adjacent contacts
;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;
02. Batch Wiring of Cables Using Solder Paste
Soldered wiring has been used as the wiring method for the
plug side composite cable, thin cable, and drain wires;
however, paste soldering permits the batch wiring of
prepared cables. (Existing soldering methods can also be
used to wire the connectors.)
03. No Shrink Tubing Required
The wiring portion of the plug side is secured by the
molding which prevents short circuits without the use of
shrink tubing. Since shrink tubing is not used, this
allows the twist back length of the twisted pair cable or
the twinax cable to be shortened, thereby permitting the
impedance of the wiring section to be kept in check.
04. Power and Signal Contacts
The 65 position connector is designed with 59 signal contacts and 6 power contacts. Each power contact is
rated for 2 Amps. The 71 position connector is supplied with signal contacts only.
05. Low-Profile Design
With the trend toward lower profiles, the receptacle is made to drop into the board, which results in a height
dimension, including the board, of 5.6mm.
2001.6
1

PagesPages 12
Télécharger [ EX60T-CCV ]


Fiche technique recommandé

No Description détaillée Fabricant
EX60T-CCT High-Speed Differential Signal Connectors Hirose Electric
Hirose Electric
EX60T-CCV High-Speed Differential Signal Connectors Hirose Electric
Hirose Electric

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche