|
|
PDF TQ2H-L-24V Data sheet ( Hoja de datos )
| Número de pieza | TQ2H-L-24V | |
| Descripción | LOW PROFILE 2 FORM C RELAY | |
| Fabricantes | ETC | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de TQ2H-L-24V (archivo pdf) en la parte inferior de esta página. Total 7 Páginas | ||
|
No Preview Available !
LOW PROFILE
2 FORM C RELAY
TESTING
TQ-RELAYS
FEATURES
9
.354
• High sensitivity:
26.7
1.051
5+0.4
–0.2
.197+–..001068
14
.551
9
.354
2 Form C: 140 mW power consumption (single side stable type)
4 Form C: 280 mW power consumption (single side stable type)
5+0.4
–0.2
.197+–..001068
• Surge voltage withstand: 1500 V FCC Part 68
• Sealed construction allows automatic washing
• Self-clinching terminal also available
• M.B.B. contact types available
mm inch
SPECIFICATIONS
Contact
Standard
(B.B.M) type
M.B.B.type
Arrangement
2 Form C 4 Form C 2 Form D
Initial contact resistance, max.
(By voltage drop 6 V DC 1A)
50 mΩ
Contact material
Gold-clad silver
Nominal switching capacity
(resistive load)
1 A 30 V DC
0.5 A 125 V AC
1 A 30 V
DC
Rating
Max. switching power
(resistive load)
Max. switching voltage
30 W, 62.5 V A
110 V DC, 125 V AC
30 W
110 V DC
Max. switching current
Min. switching capacity f1
1A
10 µA 10 mV DC
Single side stable
Nominal
operating
power 1 coil latching
140 mW
(3 to 12 V DC)
200 mW
(24 V DC)
300 mW
(48 V DC)
280 mW
(3 to 24 V DC)
400 mW
(48 V DC)
100 mW
(3 to 12 V DC)
150 mW
(24 V DC)
200 mW
200 mW
—
2 coil latching
200 mW
(3 to 12 V DC)
300 mW
(24 V DC)
400 mW
—
Expected
life (min.
opera-
tions)
Mechanical (at 180 cpm)
Electrical
(at 20 cpm)
(1 A 30 V DC
resistive)
1 A 30 V DC
resistive
0.5 A 125 V AC
resistive
108
2×105
105
107
105
—
Note:
f1This value can change due to the switching frequency, environmental conditions,
and desired reliability level, therefore it is recommended to check this with the ac-
tual load.
Remarks
* Specifications will vary with foreign standards certification ratings.
*1 Measurement at same location as "Initial breakdown voltage" section.
*2 By resistive method, nominal voltage applied to the coil; contact carrying current:
1 A.
*3 Nominal voltage applied to the coil, excluding contact bounce time.
*4 Nominal voltage applied to the coil, excluding contact bounce time without diode.
*5 Half-wave pulse of sine wave: 11 ms; detection time: 10 µs.
*6 Half-wave pulse of sine wave: 6 ms.
*7 Detection time: 10 µs.
Characteristics
Standard
(B.B.M) type
M.B.B.type
Initial insulation resistance*1
Min. 1,000 MΩ (at 500 V DC)
Initial
breakdown
voltage
Between open
contacts
Between contact
and coil
750 Vrms for 1 min. 300 Vrms for 1 min.
(Detection current: (Detection current:
10 mA)
10 mA)
1,000 Vrms for 1 min.
(Detection current: 10 mA)
Between contact
sets
1,000 Vrms for 1 min.
(Detection current: 10 mA)
FCC surge voltage between open
contacts
1,500 V
Operate time [Set time]*3
(at 20°C)
Max. 3 ms (Approx. 2 ms)
[Max. 3 ms (Approx. 2 ms)]
Release time [Reset time]*4
(at 20°C)
M.B.B. time*8
Temperature rise*2 (at 20°C)
Max. 3 ms (Approx. 1 ms)
[Max. 3 ms (Approx. 2 ms)]
— Min. 10 µs.
Max. 50°C
Functional*5
Shock resistance
Destructive*6
Min. 490 m/s2 {50G}
Min. 980 m/s2 {100G}
Vibration
resistance
Functional*7
Destructive
176.4 m/s2 {18G}, 10 to 55 Hz
at double amplitude of 3 mm
294 m/s2 {30G}, 10 to 55 Hz
at double amplitude of 5 mm
Conditions for
operation, trans-
port and storage*9
(Not freezing and
condensing at low
temperature)
Ambient
temperature
Humidity
–40°C to +70°C
–40°F to +158°F
–40°C to +50°C
–40°F to +122°F
5 to 85% R.H.
Unit weight
2 Form C:
4 Form C:
Approx. 1.5 g .053 oz
Approx. 3 g .106 oz.
—
*8 M.B.B. time:
Measuring
condition
Min. 10 µs
500 Ω
5 V DC
*9 Refer to 4. Conditions for operation, transport and storage mentioned in Cautions
for use (Page 178).
133
1 page  
4.-(1) Electrical life (DC load)
Tested sample: TQ2-12V, 6 pcs.
Condition: 1 A 30 V DC resistive load, 20 cpm
Change of pick-up and drop-out voltage
100
90
80 Pick-up voltage
70
60
Max.
Min.
50
40 Drop-out voltage
30 Max.
20 Min.
10
0 5 10 15 20
No. of operations, ×104
Change of contact resistance
100
90
80
70
60
50
40 Max.
30 Min.
20
10
0 5 10
No. of operations, ×104
6.-(1) Operate/release time characteristics
Tested sample: TQ2-12V, 10 pcs.
6
5
4
3
Operate time
2
1 Release time
Max.
Min.
Max.
Min.
0
80 90 100 110 120
Coil applied voltage, %V
Change of contact resistance
100
90
80
70
60
50 Max.
40
30 Min.
20
10
0 5 10 15 20
No. of operations, ×104
5.-(1) Coil temperature rise (2C)
Tested sample: TQ2-12V
Measured portion: Inside the coil
Ambient temperature: 30°C 86°F
70
Nominal coil voltage
60
3 to 12 V DC type
24 V DC type
50 1 A
40 1 A
0A
30
20
10
0
100 110 120 130 140 150
Coil applied voltage, %V
6.-(2) Operate/release time characteristics
Tested sample: TQ4-12V, 10 pcs.
6
5
4
3
Operate time
2
Max.
Min.
1 Max.
Min.
Release time
0
80 90 100 110 120
Coil applied voltage, %V
TQ
4.-(2) Electrical life (AC load)
Tested sample: TQ2-12V, 6 pcs.
Condition: 0.5 A 125 V AC resistive load, 20 cpm
Change of pick-up and drop-out voltage
100
90
80
Pick-up voltage
70
60
50
40 Drop-out voltage
30
20
10
Max.
Min.
Max.
Min.
0 5 10
No. of operations, ×104
5.-(2) Coil temperature rise (4C)
Tested sample: TQ4-12V
Measured portion: Inside the coil
Ambient temperature: 30°C 86°F
70
60
50
1A
40
0A
30
20
10
0
100 110 120 130 140 150
Coil applied voltage, %V
7. Distribution of pick-up and drop-out voltages
Tested sample: TQ2-12V, 50 pcs.
30
Pick-up voltage
Drop-out voltage
20
10
0 10 20 30 40 50 60 70 80 90 100
Ratio against the rated voltage, %V
8. Distribution of set and reset voltage
Tested sample: TQ2-L2-12V, 35 pcs.
30
Set voltage
Reset voltage
20
10
0 10 20 30 40 50 60 70 80 90 100
Ratio against the rated voltage, %V
9. Ambient temperature characteristics
Tested sample: TQ2-12V, 5 pcs.
10. Distribution of contact resistance
Tested sample: TQ2-12V, 30 pcs. (30×4 contacts)
–40 –20
40 Drop-out
voltage x−
20 x−
0 Pick-up voltage
20 40 60 80
Ambient temperature,°C
–20
–40
40
30
20
10
0 30 40 50
Contact resistance, mΩ
137
5 Page | ||
| Páginas | Total 7 Páginas | |
| PDF Descargar | [ Datasheet TQ2H-L-24V.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| TQ2H-L-24V | LOW PROFILE 2 FORM C RELAY | ETC |
| TQ2H-L-24V | 2-pole 5 mm Surface Mount Relay |  Panasonic |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |