DataSheetWiki


BTF1A16G-TR fiches techniques PDF

Agere Systems - Dual Differential Transceiver BTF1A With Idle Bus Indicator

Numéro de référence BTF1A16G-TR
Description Dual Differential Transceiver BTF1A With Idle Bus Indicator
Fabricant Agere Systems 
Logo Agere Systems 





1 Page

No Preview Available !





BTF1A16G-TR fiche technique
Dual Differential Transceiver BTF1A
With Idle Bus Indicator
Data Sheet
March 2001
Features
Driver Features
s Produces a logic zero in third state
s 400 mV difference voltage in third state
s Two line drivers per package
s Logic to convert TTL input logic levels to differen-
tial, pseudo-emmiter coupled logic (ECL) output
logic levels
s No line loading when VCC = 0 V
s High output driver for 50 loads
s 200 mA short-circuit current (typical)
s 2.0 ns maximum propagation delay
s <0.2 ns output skew (typical)
Receiver Features
s Two line receivers per package
s High input impedance 8 k
s Logic that converts differential input logic levels to
TTL output logic levels
s 4.0 ns maximum propagation delay
s <0.20 V input sensitivity (typical)
s 1.2 V to +7.2 V common-mode range
Common Device Features
s Common enable for each driver/receiver pair
s Operating temperature range: –40 °C to +125 °C
(wider than the 41 Series)
s Single 5.0 V ± 5% supply
s 400 Mbits/s maximum data rate
s Meets enhanced small device interface (ESDI)
standards
s Electrostatic discharge (ESD) performance better
than the 41 Series
s Lower power requirement than the 41 Series
Description
The BTF1A device is a dual differential transceiver
circuit that transmits and receives digital data over
balanced transmission lines and is compatible with
Lucent Technologies Microelectronics Group differ-
ential drivers and receivers. It is designed to provide
a strong logic zero when in the third state. The mini-
mum difference voltage in the third state is 400 mV. It
is designed specifically for bus applications where a
well-defined logic state is needed when the bus is
idle. The driver puts out a logic zero when in the third
state mode, which is easily overriden by an active
buffer on the bus. When all the buffers on the bus are
inactive (third state), the signal on the bus is a zero
indicating that the bus is idle.
The dual drivers translate input TTL logic levels to dif-
ferential pseudo-ECL output levels. The dual receiver
converts differential input logic levels to TTL output
levels. Each driver/receiver pair has its own common
enable control allowing serial data and a control clock
to be transmitted and received on a single integrated
circuit. The BTF1A transceiver requires the customer
to supply termination resistors on the circuit board.
The powerdown loading characteristics of the
receiver input circuit are approximately 8 krelative
to the power supplies; hence, it will not load the
transmission line when the circuit is powered down.
For those circuits with termination resistors, the line
will remain impedance matched when the circuit is
powered down. The driver does not load the line
when it is powered down.

PagesPages 16
Télécharger [ BTF1A16G-TR ]


Fiche technique recommandé

No Description détaillée Fabricant
BTF1A16G-TR Dual Differential Transceiver BTF1A With Idle Bus Indicator Agere Systems
Agere Systems

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche