|
|
PDF MN101CP117 Data sheet ( Hoja de datos )
| Número de pieza | MN101CP117 | |
| Descripción | (MN101CP115 / MN101CP117) LSI User Manual | |
| Fabricantes | Panasonic | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de MN101CP117 (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
|
No Preview Available !
www.DataSheet4U.com
MICROCOMPUTER MN101C00
MN101C115/117
LSI User’s Manual
Pub. No. 21411-011E
1 page  
s Manual Configuration
Each section of this manual consists of a title, summary, main text, supplemental information, precautions and
warnings. The layout and definition of each section are shown below.
Subtitle
Sub-subtitle
The smallest block
in this manual.
Main text
www.DataSheet4U.com
Key information
Important
information from
the text.
4-3 16-bit Timer Operation (timer 4)
4-3-1 Overview
Timer 4 is a 16-bit programmable counter that can be used as an event counter.
A signal with frequency of 1/2 of the timer 4 overflow signal can be output from the
TM4IO pin. An input capture function and added pulse PWM output function can
also be used.
Chapter 4 Timer Functions
s Timer Operation
Settings for timer operation are listed below.
(1) Set the TM4EN flag of the timer 4 mode register (TM4MD) to "0" so that the count
operation of timer 4 is stopped.
(2) Set the TM4CK2~0 flags of the TM4MD register to select fosc, fs/4, or fs/16 as the
clock source.
(3) Set the TM4PWM flag of the TM4MD register to "0" so that 16-bit timer operation is
selected.
Clock
TM4EN
Write to registers
TM4OCH, TM4OCL
Binary
04 05
06
07 08 09 00
counter 4
Figure 4-3-1 Binary Counter 4 (TM4BC) Count Timing
When servicing an interrupt, reset
the timer 4 interrupt request flag
before operating timer 4.
During a count operation, be
careful if the value set in TM4OCH
and TM4OCL is smaller than the
value of binary counter 4, since
the count-up operation will
continue until overflow occurs.
If the TM4EN flag of the TM4MD register is changed
simultaneously with other bits, the switching operation may cause
binary counter 4 to be incremented.
If the value of TM4OCH and TM4OCL registers is overwritten while
timer 4 has stopped counting, binary counter 4 will be reset to
X'0000'.
16-bit Timer Operation (timer 4) 83
Summary
Introduction to the
section.
Supplementary
information
Supplementary
information for the
main text. An
explanation of
terminology is also
included.
Precautions and
warnings
Precautions are
listed in case of lost
functionality or
damage.
Be sure to read.
How to Read This Manual–2
5 Page 
www.DataSheet4U.com
Chapter 3 Port Functions
3-1 Overview ......................................................................................................................38
3-2 Port Control Registers ..................................................................................................41
3-2-1 Overview ........................................................................................................41
3-2-2 I/O Port Control Registers ..............................................................................45
3-3 I/O Port Configuration and Functions..........................................................................47
Chapter 4 Timer Functions
4-1 Overview ......................................................................................................................56
4-2 8-bit Timer Operation (timers 2, 3) ..............................................................................62
4-2-1 Overview ........................................................................................................62
4-2-2 Operation ........................................................................................................63
4-3 16-bit Timer Operation (timer 4)..................................................................................69
4-3-1 Overview ........................................................................................................69
4-3-2 Operation ........................................................................................................69
4-4 8-bit Timer Operation (timer 5)....................................................................................76
4-4-1 Overview ........................................................................................................76
4-4-2 Operation ........................................................................................................76
4-5 Time Base Operation....................................................................................................77
4-5-1 Overview ........................................................................................................77
4-5-2 Operation ........................................................................................................77
4-6 Watchdog Timer Operation ..........................................................................................78
4-6-1 Overview ........................................................................................................78
4-6-2 Setup and Operation .......................................................................................78
4-7 Remote Control Output Operation ...............................................................................79
4-7-1 Overview ........................................................................................................79
4-7-2 Setup and Operation .......................................................................................79
4-8 Buzzer Output ..............................................................................................................80
4-8-1 Buzzer Output Setup and Operation ...............................................................80
4-9 Timer Function Control Registers................................................................................81
4-9-1 Overview ........................................................................................................81
4-9-2 Programmable Timer/Counters ......................................................................82
4-9-3 Timer Mode Registers ....................................................................................85
4-9-4 Timer Control Registers .................................................................................89
<Contents 2>
11 Page | ||
| Páginas | Total 30 Páginas | |
| PDF Descargar | [ Datasheet MN101CP117.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| MN101CP115 | (MN101CP115 / MN101CP117) LSI User Manual | Panasonic |
| MN101CP117 | (MN101CP115 / MN101CP117) LSI User Manual | Panasonic |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |