DataSheet.es    


PDF ATA5744 Data sheet ( Hoja de datos )

Número de pieza ATA5744
Descripción UHF ASK Receiver
Fabricantes ATMEL Corporation 
Logotipo ATMEL Corporation Logotipo



Hay una vista previa y un enlace de descarga de ATA5744 (archivo pdf) en la parte inferior de esta página.


Total 20 Páginas

No Preview Available ! ATA5744 Hoja de datos, Descripción, Manual

Features
Minimal External Circuitry Requirements, no RF Components on the PC Board Except
Matching to the Receiver Antenna
High Sensitivity, Especially at Low Data Rates
SSO20 and SO20 package
Fully Integrated VCO
Supply Voltage 4.5V to 5.5V, Operating Temperature Range –40°C to
+105°C
Single-ended RF Input for Easy Adaptation to l/4 Antenna or Printed
Antenna on PCB
Low-cost Solution Due to High Integration Level
Various Types of Protocols Supported (i.e., PWM, Manchester and
Bi-phase)
Distinguishes the Signal Strength of Several Transmitters via RSSI (Received Signal
Strength Indicator)
ESD Protection According to MIL-STD. 883 (4KV HBM)
High Image Frequency Suppression Due to 1 MHz IF in Conjunction with a SAW
Front-end Filter, up to 40 dB is thereby Achievable with Newer SAWs
Power Management (Polling) is Possible by Means of a Separate Pin via the
Microcontroller
Receiving Bandwidth BIF = 600 kHz
UHF ASK
Receiver
ATA5744
1. Description
www.DataSheet4U.com
The ATA5744 is a PLL receiver device for the receiving range of f0 = 300 MHz to
450 MHz. It is developed for the demands of RF low-cost data communication sys-
tems with low data rates and fits for most types of modulation schemes including
Manchester, Bi-phase and most PWM protocols. Its main applications are in the areas
of telemetering, security technology and keyless-entry systems.
Figure 1-1. System Block Diagram
1 Li cell
Encoder
Keys ATARx9x
UHF ASK/FSK
Remote control transmitter
UHF ASK
Remote control receiver
U2741B
ATA5744
Demod.
Data
interface
PLL
XTO
VCO
Antenna Antenna
IF Amp
PLL
XTO
1...3 Micro-
controller
Power
amp.
LNA VCO
Rev. 4893A–RKE–11/05

1 page




ATA5744 pdf
ATA5744
Figure 3-2 shows a typical input matching network for fRF = 315 MHz and fRF = 433.92 MHz
using a SAW. Figure 3-3 on page 6 illustrates the input matching to 50without a SAW. The
input matching networks shown in Figure 3-3 on page 6 are the reference networks for the
parameters given in the electrical characteristics.
Table 3-1. Calculation of LO and IF Frequency
Conditions
Local Oscillator Frequency
fRF = 315 MHz, MODE = 0
fRF = 433.92 MHz, MODE = 1
fLO = 314 MHz
fLO = 432.92 MHz
300 MHz < fRF < 365 MHz, MODE = 0
fLO
=
------f--R----F-------
1 + ----1-----
314
365 MHz < fRF < 450 MHz, MODE = 1
fLO
=
----------f--R----F-----------
1 + --------1---------
432.92
Intermediate Frequency
fIF = 1 MHz
fIF = 1 MHz
fIF
=
-f--L---O---
314
fIF
=
------f-L---O-------
432.92
Figure 3-2. Input Matching Network with SAW Filter
ATA5744
8 LNAGND
C3 L 9 LNA_IN
22p 25n
fRF = 433.92 MHz
C16 C17
100p
L3
27n
8.2p
TOKO LL2012
F27NJ
L2
RFIN
TOKO LL2012
F33NJ
1 IN
B3555
5
OUT
C2 33n 2 IN_GND
OUT_GND 6
CASE_GND
8.2p
3, 4 7, 8
ATA5744
8 LNAGND
C3
L
9
LNA_IN
47p 25n
fRF = 315 MHz
C16 C17
100p
L3
47n
22p
TOKO LL2012
F47NJ
RFIN
L2
TOKO LL2012
F82NJ
1 IN
B3551
OUT 5
C2 82n 2 IN_GND
6
OUT_GND
10p CASE_GND
3, 4 7, 8
4893A–RKE–11/05
5

5 Page





ATA5744 arduino
ATA5744
6. Digital Signal Processing
The data from the ASK demodulator (Dem_out) is digitally processed in different ways and as a
result converted into the output signal DATA. This processing depends on the selected baudrate
range (BR_Range). Figure 6-1 on page 11 illustrates how Dem_out is synchronized by the
extended basic clock cycle TXClk. Data can change its state only after TXClk has elapsed. The
edge-to-edge time period tee_sig of the DATA signal as a result is always an integral multiple of
TXClk.
The minimum time period between two edges of the data signal is limited to tee_sig TDATA_min.
This implies an efficient suppression of spikes at the DATA output. At the same time it limits the
maximum frequency of edges at DATA. This eases the interrupt handling of a connected
microcontroller.
Figure 6-1. Synchronization of the Demodulator Output
TXClk
Dem_out
Data_out (DATA)
tee_sig
Figure 6-2. Debouncing of the Demodulator Output
Dem_out
DATA
tDATA_min
tee
tDATA_min
tee
tDATA_min
tee
4893A–RKE–11/05
11

11 Page







PáginasTotal 20 Páginas
PDF Descargar[ Datasheet ATA5744.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
ATA5743UHF ASK/FSK ReceiverATMEL Corporation
ATMEL Corporation
ATA5744UHF ASK ReceiverATMEL Corporation
ATMEL Corporation
ATA5745(ATA5745 / ATA5746) UHF ASK/FSK ReceiverATMEL Corporation
ATMEL Corporation
ATA5746(ATA5745 / ATA5746) UHF ASK/FSK ReceiverATMEL Corporation
ATMEL Corporation

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar