DataSheetWiki


CCD201-20 fiches techniques PDF

E2V - Electron Multiplying CCD Sensor

Numéro de référence CCD201-20
Description Electron Multiplying CCD Sensor
Fabricant E2V 
Logo E2V 





1 Page

No Preview Available !





CCD201-20 fiche technique
CCD201-20 Back Illuminated 2-Phase IMO Series
Electron Multiplying CCD Sensor
INTRODUCTION
The CCD201 is a large format sensor (41k2) in the L3VisionTM
range of products from e2v technologies. This device uses a
novel output amplifier circuit that is capable of operating at an
equivalent output noise of less than one electron at pixel rates
of over 15 MHz. This makes the sensor well suited for scientific
imaging where the illumination is limited.
The sensor is a frame transfer device and can operate in
inverted mode to suppress dark current as this is now the
dominant noise source (even at high readout rate). The image
and store sections are designed to operate in 2-phase mode, to
maximise the highest achievable parallel transfer frequency.
The sensor functions by converting photons to charge in the
image area during the integration time period, then transferring
this charge through the image and store sections into the
readout register. Following transfer through the readout
register, the charge is multiplied in the gain register before
conversion to a voltage by an output amplifier.
The sensor has two output amplifiers; a low noise, high
responsivity output for normal CCD operation and a large
signal amplifier for when multiplication gain is employed.
Operation of the high gain mode is controlled by adjustment of
the multiplication phase amplitude R12HV.
GENERAL DATA
Active image area . . . . . . . . . 13.3 x 13.3 mm
Image section active pixels . . . . . 1024 (H) x 1024 (V)
Image pixel size . . . . . . . . . . . . 13 x 13 mm
Number of output amplifiers . . . . . . . . . . 2
Fill factor . . . . . . . . . . . . . . . 100%
Additional dark reference columns . . . . . . . 32
Additional overscan rows . . . . . . . . . . . 8
PACKAGE DETAILS (see Fig. 15)
Ceramic Package
Overall dimensions . . . . . . . . . 37.4 x 26.5 mm
Number of pins . . . . . . . . . . . . . . 36
Inter-pin spacing . . . . . . . . . . . 2.54 mm
Mounting position . . . . . . . . . . . . . any
The pin 1 marker is shown in Fig. 15.
STORAGE AND OPERATION
TEMPERATURE EXTREMES
Storage temperature (8C)
Operating temperature (8C)
Temperature ramping (8C/min)
MIN
7200
7120
MAX
+100
+75
5
Note: Operation or storage in humid conditions may give rise
to moisture on the sensor surface on cooling, causing
irreversible damage.
www.DataSheet4U.com
e2v technologies (uk) limited, Waterhouse Lane, Chelmsford, Essex CM1 2QU, UK Telephone: +44 (0)1245 493493 Facsimile: +44 (0)1245 492492
e-mail: [email protected] Internet: www.e2v.com Holding Company: e2v technologies plc
e2v technologies inc. 4 Westchester Plaza, PO Box 1482, Elmsford, NY10523-1482 USA Telephone: (914) 592-6050 Facsimile: (914) 592-5148
# e2v technologies (uk) limited 2005
A1A-100013 Issue 1, June 2005
411/9140

PagesPages 15
Télécharger [ CCD201-20 ]


Fiche technique recommandé

No Description détaillée Fabricant
CCD201-20 Electron Multiplying CCD Sensor E2V
E2V

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche