|
|
Número de pieza | AT90RF135602 | |
Descripción | INTEGRATED 13.56 MHz CONTACTLESS READER WITH EMBEDED SOFTWARE | |
Fabricantes | ATMEL Corporation | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de AT90RF135602 (archivo pdf) en la parte inferior de esta página. Total 35 Páginas | ||
No Preview Available ! Features
• Contactless Interface
– Reads and Writes Passive RFID Tags in the Unlicensed 13.56 MHz Band
– Employs ISO/IEC14443 Type A Modulation Schemes
– Autonomous Operation Capability (can scan and read tags without host
intervention – i.e. only passes data following successful read/write operation)
– Compatible with NFC Initiation Only Device – User Has Control Over Initiation of all
RFID Based Services and Features
– Read/write Operation Between 1 cm and 10 cm Read Range, Depending on
Reader/Tag Antenna Coil Sizes and Orientation Relative to the Reader
– Collision Detection as Standard
– Transparent Modes for Software Controlled Modulation Supports Maximum
Flexibility and Future Protocols
– Fast Data Communication Rate of 106 kbit/s
– Suitable for Operation with a Wide Variety of Antenna Coil Sizes and Form Factors
– Four Software Adjustable Carrier Field Drive Levels
• Controller and Software
– On-board Powerful Atmel AVR® RISC microcontroler, programmed with
Innovision® proprietary software.
– Built in Self Test and Diagnostic Modes
– Internal 8 MHz RC Oscillator for Micro or External Crystal Operation
• Host Interface
– 3-wire SPI Interface as Standard
– Full Software Control via SPI bus at 115 Kbaud as Standard Interface
• Power Supply
– Ultra Low Current Operation and Stand-by Sleep Mode Typically < 1 µA
– Ultra Low Voltage Operation: 2.7V - 3.3V
• Additional features
– Packages: LBGA36
– LBGA Requires Only an External Crystal, 10 Passives and the Reader Antenna Coil
– Operating temperature range: -30°C to +80°C
www.DataSheet4U.com
Integrated
13.56 MHz
Contactless
Reader with
Embeded
software
AT90RF135602
Description
AT90RF135602 is an ultra small footprint low-cost Radio Frequency Identification
(RFID) reader developed with Innovision Research & Technology plc to address
multi-protocol 13.56 MHz RFID applications.
It is optimised for use with the established ISO/IEC14443 type A standard and is avail-
able in Low-profile Ball Grid Array (LBGA).
The LBGA incorporates a custom transceiver front-end along with a protocol & com-
munications controller. It requires only an external crystal and minimal external
passive components to interface to the reader antenna.
Protocols are software defined and hence configurable.
4407A–SCR–04/05
1
1 page Pinout
Pin Description
4407A–SCR–04/05
Figure 3. LBGA36 Package Pinout
www.DataSheet4U.com
F EDCB A
PC4
SCK MISO MOSI
(SDO) (SDI)
/SS
XTAL2
VDDQ VCC2 VDD01 VDD02 GND1 XIN
PC6 VCC1
PC7
GND2 /Reset
(/MCLR)
XOUT
TX1
PD1
VDD
XTAL1
VSS PC5
Substrate Substrate VSS02 VSS01 VSSQ TX2
PDO PC3 PC2 RX PC1 PC0
1
2
3
4
5
6
7
8
Table 1. AT90RF15602 Pin Description
PIN Name
Pin Number
i/0/p Type
VDDQ
F2 Power
VDD
E6 Power
VDDO1 D2 Power
VDDO2 C2 Power
VCC1
E3 Power
VCC2
E2 Power
GND1
B2 Power
GND2
B3 Power
VSS
B6 Power
VSSQ
B7 Power
VSSO1 C7 Power
VSSO2 D7 Power
Description
Analogue Supply
Logic Supply
Output Stage Supply
Output Stage Supply
MCU Supply
MCU Supply
MCU GND
MCU GND
Logic GND
Analogue GND
Output Stage GND
Output Stage GND
5
5 Page SPI Interface Protocol
www.DataSheet4U.com
Serial Peripheral
Interface – SPI
Features
Figure 6. SPI Block Diagram
The Serial Peripheral Interface (SPI) allows high-speed synchronous data transfer
between the AT90RF135602 and peripheral devices or between several AVR devices.
The AT90RF135602 SPI includes the following features:
• Full-duplex, Three-wire Synchronous Data Transfer
• Master or Slave Operation
• LSB First or MSB First Data Transfer
• Seven Programmable Bit Rates
• End of Transmission Interrupt Flag
• Write Collision Flag Protection
• Wake-up from Idle Mode
• Double Speed (CK/2) Master SPI Mode
clk IO
DIVIDER
/2/4/8/16/32/64/128
4407A–SCR–04/05
11
11 Page |
Páginas | Total 35 Páginas | |
PDF Descargar | [ Datasheet AT90RF135602.PDF ] |
Número de pieza | Descripción | Fabricantes |
AT90RF135602 | INTEGRATED 13.56 MHz CONTACTLESS READER WITH EMBEDED SOFTWARE | ATMEL Corporation |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |