|
|
PDF ATTINY861A Data sheet ( Hoja de datos )
| Número de pieza | ATTINY861A | |
| Descripción | (ATTINYx61A) 8-bit Microcontroller | |
| Fabricantes | ATMEL Corporation | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de ATTINY861A (archivo pdf) en la parte inferior de esta página. Total 22 Páginas | ||
|
No Preview Available !
Features
• High Performance, Low Power AVR® 8-Bit Microcontroller
• Advanced RISC Architecture
– 123 Powerful Instructions – Most Single Clock Cycle Execution
– 32 x 8 General Purpose Working Registers
– Fully Static Operation
– Up to 20 MIPS Throughput at 20 MHz
• High Endurance Non-volatile Memory Segments
– 2/4/8K Bytes of In-System Self-Programmable Flash Program Memory
• Endurance: 10,000 Write/Erase Cycles
– 128/256/512 Bytes of In-System Programmable EEPROM
• Endurance: 100,000 Write/Erase Cycles
– 128/256/512 Bytes of Internal SRAM
– Data retention: 20 Years at 85°C / 100 Years at 25°C
– In-System Programmable via SPI Port
– Programming Lock for Software Security
• Peripheral Features
– One 8/16-bit Timer/Counter with Prescaler
– One 8/10-bit High Speed Timer/Counter with Prescaler
• 3 High Frequency PWM Outputs with Separate Output Compare Registers
• Programmable Dead Time Generator
– 10-bit ADC
• 11 Single-Ended Channels
• 16 Differential ADC Channel Pairs
• 15 Differential ADC Channel Pairs with Programmable Gain (1x, 8x, 20x, 32x)
– On-Chip Analog Comparator
– Programmable Watchdog Timer with Separate On-Chip Oscillator
– Universal Serial Interface with Start Condition Detector
– Interrupt and Wake-up on Pin Change
• Special Microcontroller Features
– debugWIRE On-Chip Debug System
– Power-on Reset and Programmable Brown-out Detection
– Internal Calibrated Oscillator
– External and Internal Interrupt Sources
– Four Sleep Modes: Low Power Idle, ADC Noise Reduction, Standby and Power-
Down
– On-Chip Temperature Sensor
• I/O and Packages
– 16 Programmable I/O Lines
– 20-pin PDIP, 20-pin SOIC, 20-pin TSSOP and 32-pad MLF
• Operating Voltage
– 1.8 – 5.5V
• Speed Grades
– 0 – 4 MHz @ 1.8 – 5.5V
– 0 – 10 MHz @ 2.7 – 5.5V
– 0 – 20 MHz @ 4.5 – 5.5V
• Power Consumption at 1 MHz, 1.8V, 25°C
– Active: 200 µA
– Power-Down Mode: 0.1 µA
8-bit
Microcontroller
with 2/4/8K
Bytes In-System
Programmable
Flash
ATtiny261A
ATtiny461A
ATtiny861A
Summary
8197CS–AVR–05/11
Free Datasheet http://www.datasheet4u.com/
1 page  
ATtiny261A/461A/861A
The ATtiny261A/461A/861A provides the following features: 2/4/8K byte of In-System Program-
mable Flash, 128/256/512 bytes EEPROM, 128/256/512 bytes SRAM, 16 general purpose I/O
lines, 32 general purpose working registers, an 8-bit Timer/Counter with compare modes, an 8-
bit high speed Timer/Counter, a Universal Serial Interface, Internal and External Interrupts, an
11-channel, 10-bit ADC, a programmable Watchdog Timer with internal oscillator, and four soft-
ware selectable power saving modes. Idle mode stops the CPU while allowing the SRAM,
Timer/Counter, ADC, Analog Comparator, and Interrupt system to continue functioning. Power-
down mode saves the register contents, disabling all chip functions until the next Interrupt or
Hardware Reset. ADC Noise Reduction mode stops the CPU and all I/O modules except ADC,
to minimize switching noise during ADC conversions. In Standby mode, the crystal/resonator
oscillator is running while the rest of the device is sleeping, allowing very fast start-up combined
with low power consumption.
The device is manufactured using Atmel’s high density non-volatile memory technology. The
On-chip ISP Flash allows the Program memory to be re-programmed In-System through an SPI
serial interface, by a conventional non-volatile memory programmer or by an On-chip boot code
running on the AVR core.
The ATtiny261A/461A/861A AVR is supported by a full suite of program and system develop-
ment tools including: C Compilers, Macro Assemblers, Program Debugger/Simulators, and
Evaluation kits.
8197CS–AVR–05/11
5
Free Datasheet http://www.datasheet4u.com/
5 Page 
ATtiny261A/461A/861A
6. Ordering Information
6.1 ATtiny261A
Speed (MHz)
Power Supply
Ordering Code (1)
Package (2)
Operational Range
ATtiny261A-MU
ATtiny261A-MUR
ATtiny261A-PU
20
1.8 – 5.5V
ATtiny261A-SU
ATtiny261A-SUR
ATtiny261A-XU
ATtiny261A-XUR
32M1-A
32M1-A
20P3
20S2
20S2
20X
20X
Industrial
(-40°C to +85°C) (3)
Notes:
20
1.8 – 5.5V
ATtiny261A-MN
ATtiny261A-MNR
32M1-A
32M1-A
Industrial
(-40°C to +105°C) (4)
1. Code indicators:
– N or U: matte tin
– R: tape & reel
2. All packages are Pb-free, halide-free and fully green and they comply with the European directive for Restriction of Hazard-
ous Substances (RoHS).
3. These devices can also be supplied in wafer form. Please contact your local Atmel sales office for detailed ordering informa-
tion and minimum quantities.
4. For typical and electrical characteristics of this device please consult “Appendix A – ATtiny261A Specification at 105°C”.
32M1-A
20P3
20S2
20X
8197CS–AVR–05/11
Package Type
32-pad, 5 x 5 x 1.0 mm Body, Lead Pitch 0.50 mm, Micro Lead Frame Package (MLF)
20-lead, 0.300" Wide, Plastic Dual Inline Package (PDIP)
20-lead, 0.300" Wide, Plastic Gull Wing Small Outline Package (SOIC)
20-lead, 4.4 mm Wide, Plastic Thin Shrink Small Outline Package (TSSOP)
11
Free Datasheet http://www.datasheet4u.com/
11 Page | ||
| Páginas | Total 22 Páginas | |
| PDF Descargar | [ Datasheet ATTINY861A.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| ATTINY861 | (ATTINYx61) 8-bit Microcontroller | ATMEL Corporation |
| ATTINY861A | (ATTINYx61A) 8-bit Microcontroller | ATMEL Corporation |
| ATTINY861V | 8-bit Microcontroller | ATMEL Corporation |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |