DataSheetWiki


AT49F8192A fiches techniques PDF

ATMEL Corporation - (AT49F008A / AT49F8192A) 8-megabit (1M x 8 / 512K x 16) Flash Memory

Numéro de référence AT49F8192A
Description (AT49F008A / AT49F8192A) 8-megabit (1M x 8 / 512K x 16) Flash Memory
Fabricant ATMEL Corporation 
Logo ATMEL Corporation 





1 Page

No Preview Available !





AT49F8192A fiche technique
Features
Single-voltage Operation
– 5V Read
– 5V Programming
Fast Read Access Time – 70 ns
Internal Erase/Program Control
Sector Architecture
– One 8K Word (16K Bytes) Boot Block with Programming Lockout
– Two 4K Word (8K Bytes) Parameter Blocks
– One 496K Word (992K Bytes) Main Memory Array Block
Fast Sector Erase Time – 10 seconds
Byte-by-byte or Word-by-word Programming – 10 µs Typical
Hardware Data Protection
Data Polling for End of Program Detection
Low Power Dissipation
– 50 mA Active Current
– 100 µA CMOS Standby Current
Typical 10,000 Write Cycles
8-megabit
(1M x 8/
512K x 16)
Flash Memory
Description
The AT49F008A(T) and AT49F8192A(T) are 5-volt, 8-megabit Flash memories orga-
nized as 1,048,576 words of 8 bits each or 512K words of 16 bits each. Manufactured
with Atmel’s advanced nonvolatile CMOS technology, the devices offer access times
to 90 ns with power dissipation of just 275 mW. When deselected, the CMOS standby
current is less than 100 µA.
The device contains a user-enabled “boot block” protection feature. Two versions of
the feature are available: the AT49F008A/8192A locates the boot block at lowest
order addresses (“bottom boot”); the AT49F008AT/8192AT locates it at highest order
addresses (“top boot”).
To allow for simple in-system reprogrammability, the AT49F008A(T)/8192A(T) does
not require high-input voltages for programming. Reading data out of the device is
similar to reading from an EPROM; it has standard CE, OE and WE inputs to avoid
bus contention. Reprogramming the AT49F008A(T)/8192A(T) is performed by first
erasing a block of data and then programming on a byte-by-byte or word-by-word
basis.
Pin Configurations
Pin Name
A0 - A18
CE
OE
WE
RESET
RDY/BUSY
I/O0 - I/O14
I/O15 (A-1)
BYTE
NC
Function
Addresses
Chip Enable
Output Enable
Write Enable
Reset
Ready/Busy Output
Data Inputs/Outputs
I/O15 (Data Input/Output, Word Mode)
A-1 (LSB Address Input, Byte Mode)
Selects Byte or Word Mode
No Connect
AT49F008A
AT49F008AT
AT49F8192A
AT49F8192AT
Rev. 1199G–FLASH–11/02
1
Free Datasheet http://www.datasheetlist.com/

PagesPages 18
Télécharger [ AT49F8192A ]


Fiche technique recommandé

No Description détaillée Fabricant
AT49F8192 8-Megabit 5-volt Only CMOS Flash Memory ATMEL Corporation
ATMEL Corporation
AT49F8192A (AT49F008A / AT49F8192A) 8-megabit (1M x 8 / 512K x 16) Flash Memory ATMEL Corporation
ATMEL Corporation
AT49F8192AT (AT49F008A / AT49F8192A) 8-megabit (1M x 8 / 512K x 16) Flash Memory ATMEL Corporation
ATMEL Corporation
AT49F8192T 8-Megabit 5-volt Only CMOS Flash Memory ATMEL Corporation
ATMEL Corporation

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche