DataSheet.es    


PDF MX29LA320DL Data sheet ( Hoja de datos )

Número de pieza MX29LA320DL
Descripción FLASH MEMORY
Fabricantes Macronix International 
Logotipo Macronix International Logotipo



Hay una vista previa y un enlace de descarga de MX29LA320DL (archivo pdf) en la parte inferior de esta página.


Total 30 Páginas

No Preview Available ! MX29LA320DL Hoja de datos, Descripción, Manual

MX29LA320D H/L
MX29LA320D H/L
DATASHEET
P/N:PM1427
REV.1.1, MAY 07, 2009
1

1 page




MX29LA320DL pdf
MX29LA320D H/L
FEATURES
32M-BIT [4M x 8 / 2M x 16] CMOS EQUAL SECTOR
FLASH MEMORY
GENERAL FEATURES
• 4,194,304 x 8 / 2,097,152 x 16 switchable
• Sixty-Four Equal Sectors with 32K word/ 64K byte
- Any combination of sectors can be erased with erase suspend/resume function
• Single Power Supply Operation
- 2.7 to 3.6 volt for read, erase, and program operations
• Latch-up protected to 100mA from -1V to 1.5 x Vcc
• Low Vcc write inhibit is equal to or less than VLKO
• Compatible with JEDEC standard
- Pinout and software compatible to single power supply Flash
PERFORMANCE
• High Performance
- Access time: 70ns
- Program time: 11us/word (typical)
- Erase time: 0.7s/sector, 35s/chip (typical)
• Low Power Consumption
- Low active read current: 9mA (typical) at 5MHz
- Low standby current: 5uA(typical)
• Typical 100,000 erase/program cycle
• 20-years data retention
SOFTWARE FEATURES
• Support Common Flash Interface (CFI)
- Flash device parameters stored on the device and provide the host system to access
• Erase Suspend/ Erase Resume
- Suspends sector erase operation to read data from or program data to another sector which is not being
erased
• Status Reply
- Data# polling & Toggle bits provide detection of program and erase operation completion
HARDWARE FEATURES
• Ready/Busy (RY/BY#) Output
- Provides a hardware method of detecting program and erase operation completion
• Hardware Reset (RESET#) Input
- Provides a hardware method to reset the internal state machine to read mode
• ACC input pin
- Provides accelerated program capability
• WP# input pin
- Write protect (WP#) function allows protection highest or lowest sector, regardless of sector protection set-
tings
SECURITY
• Sector Protection/Chip Unprotect
- Provides sector protect function to prevent program or erase operation in the protected sector
- Provides chip unprotect function to allow code changes
- Provides temporary sector unprotect function for code changes in previously protected sectors
P/N:PM1427
REV.1.1, MAY 07, 2009
5

5 Page





MX29LA320DL arduino
MX29LA320D H/L
BUS OPERATION
Table 2-1. BUS OPERATION
Mode Select
Device Reset
Standby Mode
Output Disable
Read Mode
RESET# CE# WE# OE#
LX
Vcc±0.3V disable
H enable
X
X
H
X
X
H
H enable H
L
Address
X
X
X
AIN
Write
(Program/Erase)
H enable L
H
AIN
Accelerate Program H enable L
Temporary Sector
Unprotect
Sector Protect
(Note 2)
Chip Unprotect
(Note 2)
Vhv X X
Vhv enable L
Vhv enable L
H AIN
X AIN
H
Sector Address,
A6=L, A1=H, A0=L
H
Sector Address,
A6=H, A1=H, A0=L
Q8~Q15
Word Byte
Data
(I/O)
Q0~Q7
WP#/
ACC
HighZ HighZ HighZ L/H
HighZ HighZ HighZ H
HighZ
DOUT
Note 3
HighZ HighZ L/H
Q8~Q14
=HighZ DOUT
Q15=A-1
L/H
Q8~Q14
=HighZ Note 3 Note 2
Q15=A-1
Q8~Q14
Note 3 =HighZ Note 3 Vhv
Q15=A-1
Note 3 HighZ Note 3 Note 2
X X Note 3 H
X X Note 3 H
Legend:
L=Logic LOW=Vil, H=Logic High=Vih, Vhv=10.0±0.5V, X=Don't Care, AIN=Address IN, DIN=Data IN,
DOUT=Data OUT
Notes:
1. Through programming equipment, the sector protect and chip unprotect functions can also be implemented.
2. If WP#=L, all sectors are protected. If WP# remove to H, all sectors recover previous protected or unprotected
status, determined by "sector protect" or "chip unprotect" function.
3. By following the requests of command sequence, sector protection, or data polling algorithm, Q0~Q15 would
be Data Input or Data Output.
4. In Word mode, A20~A0 are address pins. In Byte mode A20~A-1 are address pins. In both modes, A20~A15
are sector address.
P/N:PM1427
REV.1.1, MAY 07, 2009
11

11 Page







PáginasTotal 30 Páginas
PDF Descargar[ Datasheet MX29LA320DL.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
MX29LA320DHFLASH MEMORYMacronix International
Macronix International
MX29LA320DLFLASH MEMORYMacronix International
Macronix International

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar