|
|
PDF dsPIC33FJ16GP102 Data sheet ( Hoja de datos )
| Número de pieza | dsPIC33FJ16GP102 | |
| Descripción | 16-Bit Digital Signal Controllers | |
| Fabricantes | Microchip Technology | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de dsPIC33FJ16GP102 (archivo pdf) en la parte inferior de esta página. Total 70 Páginas | ||
|
No Preview Available !
dsPIC33FJ16(GP/MC)101/102 AND
dsPIC33FJ32(GP/MC)101/102/104
16-Bit Digital Signal Controllers
(up to 32-Kbyte Flash and 2-Kbyte SRAM)
Operating Conditions
• 3.0V to 3.6V, -40°C to +125°C, DC to 16 MIPS
• 3.0V to 3.6V, -40°C to +150°C, DC to 5 MIPS
Core: 16-Bit dsPIC33F CPU
• Code-Efficient (C and Assembly) Architecture
• Two 40-Bit Wide Accumulators
• Single-Cycle (MAC/MPY) with Dual Data Fetch
• Single-Cycle Mixed-Sign MUL plus Hardware Divide
• 32-Bit Multiply Support
Clock Management
• ±0.25% Internal Oscillator
• Programmable PLLs and Oscillator Clock Sources
• Fail-Safe Clock Monitor (FSCM)
• Independent Watchdog Timer (WDT)
• Fast Wake-up and Start-up
Power Management
• Low-Power Management modes (Sleep, Idle, Doze)
• Integrated Power-on Reset and Brown-out Reset
• 1 mA/MHz Dynamic Current (typical)
• 30 µA IPD Current (typical)
PWM
• Up to Three PWM Pairs
• Two Dead-Time Generators
• 31.25 ns PWM Resolution
• PWM Support for:
- Inverters, PFC, UPS
- BLDC, PMSM, ACIM, SRM
• Class B-Compliant Fault Inputs
• Possibility of ADC Synchronization with PWM Signal
Advanced Analog Features
• ADC module:
- 10-bit, 1.1 Msps with four S&H
- Four analog inputs on 18-pin devices and up to
14 analog inputs on 44-pin devices
• Flexible and Independent ADC Trigger Sources
• Three Comparator modules
• Charge Time Measurement Unit (CTMU):
- Supports mTouch™ capacitive touch sensing
- Provides high-resolution time measurement (1 ns)
- On-chip temperature measurement
Timers/Output Compare/Input Capture
• Up to Five General Purpose Timers:
- One 16-bit and up to two 32-bit timers/counters
• Two Output Compare modules
• Three Input Capture modules
• Peripheral Pin Select (PPS) to allow Function Remap
Communication Interfaces
• UART module (4 Mbps):
- With support for LIN/J2602 Protocols and IrDA®
• 4-Wire SPI module (8 MHz maximum speed):
- Remappable pins in 32-Kbyte Flash devices
• I2C™ module (400 kHz)
Input/Output
• Sink/Source 10 mA or 6 mA, Pin-Specific for Standard
VOH/VOL, up to 16 mA or 12 mA for Non-Standard VOH1
• 5V Tolerant Pins
• Up to 20 Selectable Open-Drain and Pull-ups
• Three External Interrupts (two are remappable)
Qualification and Class B Support
• AEC-Q100 REV G (Grade 0 -40°C to +150°C)
• Class B Safety Library, IEC 60730, UDE Certified
Debugger Development Support
• In-Circuit and In-Application Programming
• Up to Three Complex Data Breakpoints
• Trace and Run-Time Watch
2011-2014 Microchip Technology Inc.
DS70000652F-page 1
1 page  
dsPIC33FJ16(GP/MC)101/102 AND dsPIC33FJ32(GP/MC)101/102/104
Pin Diagrams (Continued)
20-Pin SSOP
= Pins are up to 5V tolerant
MCLR
PGED2/AN0/C3INB/C1INA/CTED1/CN2/RA0
PGEC2/AN1/C3INA/C1INB/CTED2/CN3/RA1
PGED1/AN2/C2INA/C1INC/RP0(1)/CN4/RB0
PGEC1/AN3/CVREFIN/CVREFOUT/C2INB/C1IND/RP1(1)/CN5/RB1
VSS
OSCI/CLKI/CN30/RA2
OSCO/CLKO/CN29/RA3
PGED3/SOSCI/RP4(1)/CN1/RB4
PGEC3/SOSCO/T1CK/CN0/RA4
1
2
3
4
5
6
7
8
9
10
20 AVDD
19 AVSS
18 RP15(1)/CN11/RB15
17 RTCC/RP14(1)/CN12/RB14
16 VDD
15 VCAP
14 VSS
13 SDA1/SDI1/RP9(1)/CN21/RB9
12 SCL1/SDO1/RP8(1)/CN22/RB8
11 SCK1/INT0/RP7(1)/CN23/RB7
MCLR
PGED2/AN0/C3INB/C1INA/CTED1/CN2/RA0
PGEC2/AN1/C3INA/C1INB/CTED2/CN3/RA1
PGED1/AN2/C2INA/C1INC/RP0(1)/CN4/RB0
PGEC1/AN3/CVREFIN/CVREFOUT/C2INB/C1IND/RP1(1)/CN5/RB1
VSS
OSCI/CLKI/CN30/RA2
OSCO/CLKO/CN29/RA3
PGED3/SOSCI/AN9/RP4(1)/CN1/RB4
PGEC3/SOSCO/AN10/T1CK/CN0/RA4
1
2
3
4
5
6
7
8
9
10
20 AVDD
19 AVSS
18 RP15(1)/CN11/RB15
17 RTCC/RP14(1)/CN12/RB14
16 VDD
15 VCAP
14 VSS
13 SDA1/RP9(1)/CN21/RB9
12 SCL1/RP8(1)/CN22/RB8
11 INT0/RP7(1)/CN23/RB7
Note 1: The RPn pins can be used by any remappable peripheral. See Table 1 for the list of available peripherals.
2011-2014 Microchip Technology Inc.
DS70000652F-page 5
5 Page 
dsPIC33FJ16(GP/MC)101/102 AND dsPIC33FJ32(GP/MC)101/102/104
Pin Diagrams (Continued)
28-Pin QFN(2)
= Pins are up to 5V tolerant
PGED1/AN2/C2INA/C1INC/RP0(1)/CN4/RB0
PGEC1/AN3/CVREFIN/CVREFOUT/C2INB/C1IND/RP1(1)/CN5/RB1
AN4/C3INC/C2INC/RP2(1)/CN6/RB2
AN5/C3IND/C2IND/RP3(1)/CN7/RB3
VSS
OSCI/CLKI/CN30/RA2
OSCO/CLKO/CN29/RA3
28 27 26 25 24 23 22
1 21
2 20
3 19
4 dsPIC33FJ16MC102 18
5 17
6 16
7 15
8 9 10 11 12 13 14
PWM1L2/RP13(1)/CN13/RB13
PWM1H2/RP12(1)/CN14/RB12
PWM1L3/RP11(1)/CN15/RB11
PWM1H3/RP10(1)/CN16/RB10
VCAP
VSS
SDA1/SDI1/RP9(1)/CN21/RB9
Note 1:
2:
3:
The RPn pins can be used by any remappable peripheral. See Table 1 for the list of available peripherals.
The metal pad at the bottom of the device is not connected to any pins and is recommended to be connected
to VSS externally.
The PWM Fault pins are enabled and asserted during any Reset event. Refer to Section 15.2 “PWM Faults”
for more information on the PWM Faults.
2011-2014 Microchip Technology Inc.
DS70000652F-page 11
11 Page | ||
| Páginas | Total 70 Páginas | |
| PDF Descargar | [ Datasheet dsPIC33FJ16GP102.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| dsPIC33FJ16GP101 | 16-Bit Digital Signal Controllers | Microchip Technology |
| dsPIC33FJ16GP102 | 16-Bit Digital Signal Controllers | Microchip Technology |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |