|
|
PDF M270DAN01.1 Data sheet ( Hoja de datos )
| Número de pieza | M270DAN01.1 | |
| Descripción | Color TFT-LCD | |
| Fabricantes | AUO | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de M270DAN01.1 (archivo pdf) en la parte inferior de esta página. Total 39 Páginas | ||
|
No Preview Available !
Product Specification
AU OPTRONICS CORPORATION
M270DAN01.1
(V) Preliminary Specification
(V) Final Specification
Module
Model Name
27.0” Color TFT-LCD
M270DAN01.1
Customer
Date
Approved by
Note: This Specification is subject to
change without notice.
Approved by
Date
Howard Lee
Jan 10, 2013
Prepared by
Date
ShinYu Lin
Mar 20, 2013
AU Optronics corporation
document version 0.2
1
1 page  
Product Specification
AU OPTRONICS CORPORATION
M270DAN01.1
1 Handling Precautions
1) Since front polarizer is easily damaged, pay attention not to scratch it.
2) Be sure to turn off power supply when inserting or disconnecting from input connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration or spots.
4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
5) Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface.
6) Since CMOS LSI is used in this module, take care of static electricity and insure human earth
when handling.
7) Do not open or modify the Module Assembly.
8) Do not press the reflector sheet at the back of the module to any directions.
9) In case a TFT-LCD Module has to be put back into the packing container slot after once it was
taken out from the container, do not press the center of the LED lightbar edge. Otherwise the
TFT-LCD Module may be damaged.
10) Insert or pull out the interface connector, be sure not to rotate nor tilt it of the TFT-LCD Module.
11) Do not twist nor bend the TFT -LCD Module even momentary. It should be taken into
consideration that no bending/twisting forces are applied to the TFT-LCD Module from outside.
Otherwise the TFT-LCD Module may be damaged.
12) Please avoid touching COF position while you are doing mechanical design.
13) When storing modules as spares for a long time, the following precaution is necessary:
Store them in a dark place. Do not expose the module to sunlight or fluorescent light. Keep the
temperature between 5℃ and 35℃ at normal humidity.
document version 0.2
5
5 Page 
Product Specification
AU OPTRONICS CORPORATION
M270DAN01.1
The gray to gray response time is defined as the following table. The algorithm is┃Gray Level A –
Gray Level B┃≧256.
Gray Level to Gray Level
G0
Falling Time
G255
G511
G767
G1023
G0
G255
Rising Time
G511
G767
G1023
TGTG_typ is the total average time at rising time and falling time of gray to gray.
TGTG_max is the maximum time at rising time or falling time of gray to gray.
Note 2-7: Crosstalk measurement
Definition:
CT = Max. (CTH,CTV);
Where
a.Maximum Horizontal Crosstalk :
CTH = Max. (| YBL – YAL | / YAL × 100 %, | YBR – YAR | / YAR × 100 %);
Maximum Vertical Crosstalk:
CTV = Max. (| YBU – YAU | / YAU × 100 %, | YBD – YAD | / YAD × 100 %);
b. YAU, YAD, YAL, YAR = Luminance of measured location without Black pattern
YBU, YBD, YBL, YBR = Luminance of measured location with Black pattern
Gray 511
Black
Gray 511
document version 0.2
11
11 Page | ||
| Páginas | Total 39 Páginas | |
| PDF Descargar | [ Datasheet M270DAN01.1.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| M270DAN01.0 | Color TFT-LCD | AUO |
| M270DAN01.1 | Color TFT-LCD | AUO |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |