DataSheet.es    


PDF TX43D90VM0BAA Data sheet ( Hoja de datos )

Número de pieza TX43D90VM0BAA
Descripción WXGA IPS-Pro-TFT module
Fabricantes Hitachi 
Logotipo Hitachi Logotipo



Hay una vista previa y un enlace de descarga de TX43D90VM0BAA (archivo pdf) en la parte inferior de esta página.


Total 20 Páginas

No Preview Available ! TX43D90VM0BAA Hoja de datos, Descripción, Manual

Hitachi Displays, Ltd.
Date; May. 20, 2011
TENTATIVE
TECHNICAL DATA
TX43D90VM0BAA
CONTENTS
No. Item
— COVER
— RECORD OF REVISION
— APPLICATION
— DESCRIPTION
1 ABSOLUTE MAXIMUM RATINGS
2 OPTICAL CHARACTERISTICS
3 ELECTRICAL CHARACTERISTICS
4 BLOCK DIAGRAM
5 INTERFACE PIN ASSIGNMENT
6 TIMING DIAGRAMS OF INTERFACE TIMING
7 DIMENSIONAL OUTLINE
Sheet No.
DPBC10000118-1
DPBC10000118-1
DPBC10000118-1
DPBC10000118-1
DPBC10000118-1
DPBC10000118-1
DPBC10000118-1
DPBC10000118-1
DPBC10000118-1
DPBC10000118-1
DPBC10000118-1
Page
1-1/1
2-1/1
3-1/1
4-1/1
5-1/1
6-1/2 - 6-2/2
7-1/2 - 7-2/2
8-1/1
9-1/6 - 9-6/6
10-1/3 - 10-3/3
11-1/1
The information described in this technical specification is tentative and it is possible to be changed
without prior notice.
Hitachi Displays, Ltd.
Sh.
No.
DPBC10000118-1
Page 1-1/1

1 page




TX43D90VM0BAA pdf
1. ABSOLUTE MAXIMUM RATINGS
1.1 ENVIRONMENT ABSOLUTE MAXIMUM RATINGS
Item
Operating
Min.
Max.
Storage
Min.
Max.
Unit
Note
Temperature
0
50 -20 60 °C 1)
Humidity
2)
2)
%RH
1)
Vibration
Shock
4.9 (0.5G)
29.4 (3G)
9.8 (1.0G)
294 (30G)
m/s2
3)
4)
Corrosive Gas
Not Acceptable
Not Acceptable
——
Illumination at
LCD Surface
50,000
50,000
lx —
Notes 1) Temperature and Humidity should be applied to the center glass surface of TFT-LCD module,
not to the system installed with a module.
The temperature at the center of rear surface should be less than 60°C on the condition of operating.
Function of module is guaranteed in above operating temperature range, but optical characteristics
is specified for only 25°C operating condition.
2) Ta 40°C ……… Relative humidity should be less than 85%RH max. Dew is prohibited.
Ta > 40°C ……… Relative humidity should be lower than the moisture of the 85%RH at 40°C.
3) Frequency of the vibration is between 15Hz and 50Hz. (Remove the resonance point)
4) Pulse width of the shock is 3 ms.
1.2 ELECTRICAL ABSOLUTE MAXIMUM RATINGS
(1) TFT-LCD Module
Item
Symbol
Min.
Power Supply Voltage
Differential signal input voltage
Input Voltage for logic
Electrostatic Durability
Notes 1) It is applied to LVDS signal.
VDD
VIL
VI
VESD0
VESD1
0
0
-0.3
±100
±8
2) It is applied to except LVDS signal.
3) Discharge Coefficient: 200pF-0, Environmental: 25°C-70%RH
4) Discharge Coefficient: 200pF-250, Environmental: 25°C-70%RH
5) It is applied to I/F connector pins.
6) It is applied to the surface of a metallic bezel and a LCD panel.
Max.
6.5
3.4
5.0
Unit
V
V
V
V
kV
Vss=0V
Note
1)
2)
3),5)
4),6)
(2) Back-Light
Item
Symbol
Input Voltage
ON/OFF Control Input Voltage
VIN
ON/OFF
Analog Dimming Signal Voltage
PWM Dimming Signal Voltage
VBC
PWM
Notes 1) These signals can’t input at the same time.
Min.
0
0
0
0
Max.
(15.0)
5.0
3.6
5.5
Unit
V
V
V
V
Vss=0V
Note
1)
1)
Hitachi Displays, Ltd.
Date May. 20, 2011
Sh.
No.
DPBC10000118-1
Page 5-1/1

5 Page





TX43D90VM0BAA arduino
5. INTERFACE PIN ASSIGNMENT
5.1 TFT-LCD MODULE
CN1: JAE: FI-X30SSLA-HF or Equivalent
(Matching connector: JAE: FI-X30HL or FI-X30C2L-NPB or Equivalent)
Pin No. Symbol
Function
Note
1 VDD
2
3
VDD
VDD
Power Supply (+5.0V)
4)
4 VDD
5 VSS
6
7
VSS
VSS
GND (0V)
1)
8 VSS
9 TEST1 Test Pin (OPEN)
3)
10 TEST2 Test Pin (OPEN)
3)
11 VSS GND (0V)
1)
12
13
RX0-
RX0+
Pixel Data
2)
14 VSS GND (0V)
1)
15
16
RX1-
RX1+
Pixel Data
2)
17 VSS GND (0V)
18
19
RX2-
RX2+
Pixel Data
1)
20 VSS GND (0V)
1)
21
22
CLK-
CLK+
Pixel Clock
2)
23 VSS GND (0V)
1)
24
25
RX3-
RX3+
Pixel Data
2)
26 VSS GND (0V)
1)
27 AMODE LVDS Mode Select
5)
28 TEST3 Test Pin (OPEN)
3)
29 TEST4 Test Pin (OPEN)
3)
30 VSS GND (0V)
1)
Notes 1) All Vss pins should be grounded.
2) RXn- and RXn+ (n=0,1,2,3), CLK- and CLK+ should be wired by twist-pairs
or side-by-side FPC patterns, respectively.
3) Please keep open. HITACHI test only.
4) All VDD pins should be connected to +5.0 V (typ.).
5) Please refer to page 9-4/6 "LVDS interface"
for LVDS data mapping.
6) Pin assignment is as follows.
1pin
30pin
(Figure from top-view)
Hitachi Displays, Ltd. Date May. 20, 2011 Sh.
No.
DPBC10000118-1
Page 9-1/6

11 Page







PáginasTotal 20 Páginas
PDF Descargar[ Datasheet TX43D90VM0BAA.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
TX43D90VM0BAAWXGA IPS-Pro-TFT moduleHitachi
Hitachi

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar