DataSheet.es    


PDF LP150X10-A3 Data sheet ( Hoja de datos )

Número de pieza LP150X10-A3
Descripción LCD Module
Fabricantes LG 
Logotipo LG Logotipo



Hay una vista previa y un enlace de descarga de LP150X10-A3 (archivo pdf) en la parte inferior de esta página.


Total 30 Páginas

No Preview Available ! LP150X10-A3 Hoja de datos, Descripción, Manual

Global LCD Panel Exchange Center
www.panelook.com
TO: TOSHIBA CORPORATION
DATE: ’04.05.31.
Specification Rev. 0.1
Specification of 15.0” TFT/LCD
MODEL: LP150X10(A3)
1 / 57
Prepared
Checked
Approved
J.S. Park
/Eng. Dept.
/Engineer
G.J. Han
/Eng. Dept.
/Manager
J.H. Lee
/Eng. Dept.
/Senior Mgr
S.W. Yoon
/QA. Dept.
/Senior Mgr
NOTICE of RECEIPT
We accepted this specification. OME Operations, TOSHIBA Corp.
Purchasing
Dept.
Eng.
Senr. Eng.
Senr. Mgr
PC
Hardware
Dept.
Eng.
Senr. Eng.
Senr. Mgr
LG.Philips LCD.,Co.Ltd
Date: 2004.6.2
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com

1 page




LP150X10-A3 pdf
Global LCD Panel Exchange Center
www.panelook.com
2.2. Dimensional Outline
( Front figure )
Specification Rev. 0.1
5 / 57
LG.Philips LCD.,Co.Ltd
Date: 2004.6.2
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com

5 Page





LP150X10-A3 arduino
Global LCD Panel Exchange Center
www.panelook.com
Specification Rev. 0.1
11 / 57
3.3. Mechanical Ratings
Test Item
Test Conditions
Note
Mechanical Vibration
Frequency Range 5 - 500 Hz, 14.7m/s2 1.5G) constant,
0.5Hrs each axis (X, Y, Z direction).
Frequency Range 5 - 500 Hz, 4.9m/s2 ( 0.5G) constant,
0.5Hrs each axis (X, Y, Z direction).
Non Operation
Operation
Mechanical Shock
LCD fix condition
-> See Note (2)
* 240G, Pulse width 2 ms, Sine Wave, rX, rY, rZ direction.
70G, Pulse width 11ms, Sine Wave rX, rY, rZ direction.
* Note) Normal function is only checking points.
98 m/s2 (10G), Pulse width 11 ms, Sine Wave, rX, rY, rZ direction.
Non Operation
Operation
Pressure Resistanace
-> See Note (1)
No Destruction with the force 196 N (20 kgf, 16 mm in diameter) to
the display surface at the vertical direction.
No Destruction with the force 294.2 N (30 kgf, 30 mm in diameter)
to the back of the display surface at the vertical direction.
Only the breakage of below items will not happen after test.
( Glass.Lamp & Circuit parts)
Non Operation
Fig 1-1
Fig 1-2
Fig 1-3
Strength of FL Cable
Strength of
Rotation
force
Lead Pull
Test
Cable : No disconnection of cable to the 5 trial of
Non Operation
360 degree rotation. See a bended state of cable.
Connector : No disconnection of cable to 10 trial of
180 degree rotation. See a bended state of cable.
Soldering portion 29.4N(3.0kgf) 10mins
*1.08mm Wire applied
Connector : 12.9N (1.32kgf) 1 sec
*1.08mm Wire applied
FL cable
R2
Input connector : With 50 times of connector trial there must be no
damage to the shape and functionaly.
Connector tension test
Non Operation
Back light connector : With 50 times of connector trial there must be
no damage to the shape and functionaly.
Assured torque value M2 : Max 3.0 kgf
at side-mout part
Non Operation
Rescrewed test
15 times under Max. torque
Non Operation
Tapping test
Tapping area : All bezel(Metal cover) side,
LCD: Full-screen gray (L32).
“Ripple (Pooling )” can not be seen in Active Area
Tapping Force: Max 3kgf.cm
Operation
Definitions of failure for judgment shall be as follows:
(1) Function of the module should be maintained.
(2) Current consumption should be smaller than the specified value.
(3) Appearance and display quality should not have distinguished degradation.
(4) Luminance should be larger than the minimum value specified in optical specification.
LG.Philips LCD.,Co.Ltd
Date: 2004.6.2
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com

11 Page







PáginasTotal 30 Páginas
PDF Descargar[ Datasheet LP150X10-A3.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
LP150X10-A3LCD ModuleLG
LG
LP150X10-A3K3Liquid Crystal DisplayLG
LG

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar