|
|
Número de pieza | LSC480HJ02 | |
Descripción | TFT LCD | |
Fabricantes | Samsung | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de LSC480HJ02 (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
No Preview Available ! Product Specification
( √ ) Preliminary Specification
( ) Approval Specification
The information described in this specification is preliminary and can be
changed without prior notice.
CUSTOMER
DATE OF ISSUE
Konka
2013/08/16
MODEL NO.
EXTENSION CODE
LSC480HJ02
-
Approved by
2013/08/16
Prepared by
2013/08/16
LCD Sales & Marketing Team
Samsung Display Co., Ltd
1 page ————————————————————————————————————————————————–
2. ABSOLUTE MAXIMUM RATINGS
If the figures on measuring instruments exceed maximum ratings, it can cause the malfunction or the
unrecoverable damage on the device.
Item
Power supply voltage
Temperature for storage
(Temperature of glass surface)
Humidity for storage
Operating temperature
Operating humidity
Endurance on static electricity
Symbol
V
DD
T
STG
H
STG
T
OPR
H
STG
Min.
10.8
-20
5
0
20
Max.
13.2
65
90
50
90
150
Unit
V
C
%RH
C
%RH
V
Note
(1)
(2), (4)
(2), (5)
(3)
Note (1) The power supply voltage at Ta= 25 ± 2 °C
(2) Temperature and the range of relative humidity are shown in the figure below.
a. 90 % RH Max. (Ta ≤ 39 °C)
b. The relative humidity is 90% or less. (Ta >39 °C)
c. No condensation
(3) Keep the static electricity under 150V in process the polarizer is attached on glass.
(4) Storage condition with glass.
(5) Operating condition with assembly
(6) Condition without packing.(Unpacking condition)
Fig. Range for temperature and relative humidity (unpacking condition)
——————————————————————————————————————————————––—
Doc.No. LSC480HJ02
Page 5 of 36
Rev.No. 06-000-G-20130816
5 Page ————————————————————————————————————————————————–
Note (1) No connection: These PINS are used only for the product of SAMSUNG.
(DO NOT CONNECT the input device to these pins.)
Note (2) Pin No. 1, 2, 3 are used only for I2C communication in flicker tuning.
(Refer to 9.5 Process Executing Guide)
Note (3) If set input is 8bit LVDS signal, Keep Echannel level „0‟
Pin No.24 / Pin No.40 : Pull up(3.3V) with 1.5Kohm resistor
Pin No.25 / Pin No.41 : Pull down(GND) with 1.5Kohm resistor
Note (4) The selection of 3D input format - Format[1:0]
Format1
NC
Low
Low
High
High
Format0
NC
Low
High
Low
High
Input Frame
Line Interleave
Don’t use
Tom/Bottom
Note (5) LVDS signal pin have Negative/Positive 100ohm as termination resister.
100ohm serial damping resister is connected except LVDS signal
Note (6) Pin number which starts from the left side.
Fig . The diagram of connector
a. Power GND pins should be connected to the LCD‟s metal chassis.
b. All power input pins should be connected together.
c. All NC pins should be separated from other signal or power.
——————————————————————————————————————————————––—
Doc.No. LSC480HJ02
Page 11 of 36
Rev.No. 06-000-G-20130816
11 Page |
Páginas | Total 30 Páginas | |
PDF Descargar | [ Datasheet LSC480HJ02.PDF ] |
Número de pieza | Descripción | Fabricantes |
LSC480HJ01 | TFT LCD | Samsung |
LSC480HJ02 | TFT LCD | Samsung |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |