DataSheet.es    


PDF FCB-MA130 Data sheet ( Hoja de datos )

Número de pieza FCB-MA130
Descripción 13 Mega Pixels Digital Camera Module
Fabricantes Sony 
Logotipo Sony Logotipo



Hay una vista previa y un enlace de descarga de FCB-MA130 (archivo pdf) en la parte inferior de esta página.


Total 18 Páginas

No Preview Available ! FCB-MA130 Hoja de datos, Descripción, Manual

13 Mega Pixels Digital Camera Module - Specification
FCB-MA130
Version 1.0 4th Mar, 2013
1 Cover Page and Summary of Specification
Progressive scan CMOS image sensor
Number of total pixels
4216 (H) x 3160 (V)
Image sensor
Image size
Diagonal 7.33mm (Type 1/2.45)
Color filter
Primary color Bayer arrangement
Lens
Unit cell size
Horizontal angle of view
F value
1.4um(H) x 1.4um(V)
Movie Mode: 53°
Still Capture Mode : 58°
1:2.8
Outline Image
Focus Control
Focus Range
Mechanics
100mm to infinity (in horizontal posture)
Piezo actuator motor
Focus Control
One Push Focus, Manual Focus
Expose Control Auto, Hold, Manual, Shutter Priority, Gain Priority
White Balance
Auto, Hold, ATW, Fixed(6Mode)
Face Detection(On/Off)
Image Signal
Function
Image Stabilizer(On/Off)
Noise Reduction : 3DNR(On/Off)
Wide Dynamic Range : ATR(On/Off)
Output Image
format
I/O pins
YCbCr422
Still Capture Mode : Maximum Image Size: 4192(H) x 3104(V)
Movie Mode : 30.0fps/25.0fps / Maximum Image Size 1920(H) x 1080(V)
Image signal I/O
CMOS Clock 81MHz, Parallel 16bit(YCbCr422 / SAV, EAV
selectable) / Sync Signal (HD, VD)
MIPI D-PHY Clock 324MHz, Data 2lane CSI-2 (YCbCr422)
Control signal I/O
I2C Serial Bus
Power supply
Multiple DC : 3.3±0.1[V], 1.8±0.1[V], 1.2-0.05/+0.1[V]
Power consumption
700mW (Typ. at Movie Mode)
Power, others
Storage temperature
Operating temperature
-20 to +60 degrees
-5 to +50 degrees
Module dimensions
W16.5[mm] x D18.0[mm] x H10.3[mm] (without projection)
Module mass
2.2gram
Sony reserves the right to change products and specifications without prior notice. This information does not convey any license by any
implication or otherwise under any patents or other right. Application circuits shown, if any, are typical examples illustrating the operation of
the devices. Sony cannot assume responsibility for any problems arising out of the use of these circuits.
Sony Corporation

1 page




FCB-MA130 pdf
FCB-MA130
Version 1.0 4th Mar, 2013
4 Pin Description
4.1 Table of Pin Assignment
Pin
No.
Symbol
I/O
Type of Power
Supply
Description
1 GND(AF) -
- Ground (*1)
2 GND(AF) -
- Ground (*1)
3 VDD_33(AF) -
- Power Supply (3.3V) (*1)
4 VDD_33(AF) -
- Power Supply (3.3V) (*1)
5 VDD_33 -
- Power Supply (3.3V)
6 VDD_12 -
- Power Supply (1.2V)
7 VDD_12 -
- Power Supply (1.2V)
8 VDD_12 -
- Power Supply (1.2V)
9 VDD_18 -
- Power Supply (1.8V)
10 GND
-
- Ground
11 GND
-
- Ground
12
STRB
O
VDD_18
Camera Strobe Signal
13
TRIG
O
VDD_18
Mode Transition Signal
14
C7
O
VDD_33
Digital Video Data (Chroma Parallel Data 7)
15
C6
O
VDD_33
Digital Video Data (Chroma Parallel Data 6)
16
C5
O
VDD_33
Digital Video Data (Chroma Parallel Data 5)
17
C4
O
VDD_33
Digital Video Data (Chroma Parallel Data 4)
18
C3
O
VDD_33
Digital Video Data (Chroma Parallel Data 3)
19
C2
O
VDD_33
Digital Video Data (Chroma Parallel Data 2)
20
C1
O
VDD_33
Digital Video Data (Chroma Parallel Data 1)
21
C0
O
VDD_33
Digital Video Data (Chroma Parallel Data 0)
22
DCLK
O
VDD_33
Digital Video Clock
23
Y7
O
VDD_33
Digital Video Data (Luminance Parallel Data7)
24
Y6
O
VDD_33
Digital Video Data (Luminance Parallel Data6)
25
Y5
O
VDD_33
Digital Video Data (Luminance Parallel Data5)
26
Y4
O
VDD_33
Digital Video Data (Luminance Parallel Data4)
27
Y3
O
VDD_33
Digital Video Data (Luminance Parallel Data3)
28
Y2
O
VDD_33
Digital Video Data (Luminance Parallel Data2)
29
Y1
O
VDD_33
Digital Video Data (Luminance Parallel Data1)
30
Y0
O
VDD_33
Digital Video Data (Luminance Parallel Data0)
31
HD
O
VDD_33
Digital Video H-Active Signal
32
VD
O
VDD_33
Digital Video V-Active Signal
33 GND O
- Ground
34 MIPI_D0- O
(*3) MIPI Output Data Lane0(-)
35 MIPI_D0+ O
(*3) MIPI Output Data Lane0(+)
36 MIPI_CK-
O
(*3) MIPI Output Clock(-)
37 MIPI_CK+ O
(*3) MIPI Output Clock(+)
38 MIPI_D1- O
(*3) MIPI Output Data Lane1(-)
39 MIPI_D1+ O
(*3) MIPI Output Data Lane1(+)
40 GND O
- Ground
41 XRST
I
VDD_18
System Reset, or not connected
42
SDA
IO
VDD_18
I2C Serial Bus Data I/O (*2)
43 SCL
I
VDD_18
I2C Serial Bus Clock (*2)
44 GND O
- Ground
45 GND O
- Ground
Note )
(*1) Pin No.1 to 4 are for AF driver power & ground.
(*2) An external pull-up resistor(10k) is recommended.
(*3) MIPI is based on D-PHY
Sony Corporation
5

5 Page





FCB-MA130 arduino
6.5.2 I2C Bus Timing
FCB-MA130
Version 1.0 4th Mar, 2013
Item
SCL clock frequency
Low period of SCL
High period of SCL
Rise time of SDA and SCL
Fall time of SDA and SCL
Symbol
fSCL
tSCL_LOW
tSCL_HIGH
tR
tF
Pin
SCL
SCL
SCL
SDA, SCL
SDA, SCL
Min.
Max.
Unit
0 400 kHz
1.3 - us
0.6 - us
- 300 ns
- 300 ns
Note) The camera may force the SCL level to be low level in order to notify the host that the camera module is not ready
to receive the I2C data.
SP
SCL
SDA
tBUF
tHD;STA
tSU;DAT tHD;DAT
tSU;STO
VIH
VIL
VIH
VIL
Start Condition
Stop Condition
Item
Symbol
Pin
Min. Max.
Bus free time before transmission
tBUF SDA, SCL
1.3
Hold time for START condition
Data hold time
tHD;STA
tHD;DAT
SDA, SCL
SDA, SCL
0.6
0*1
Data set-up time
tSU;DAT SDA, SCL
100
Set-up time for STOP condition
tSU;STO SDA, SCL
0.6
*1 Data hold time should be more than 300 ns considering the fall time of SCL (Max. 300 ns)
-
-
-
-
-
Unit
us
us
us
ns
us
Note) At the camera start-up, no I2C communication is allowed until the camera initialization is finished. The camera
module notifies the completion of the initialization. For the details, refer to the User Interface Control Specification.
Note) The disturbance of the I2C bus by the camera module might occur at the camera start-up. It is preferable to refrain
from communicating with the other devices on the I2C bus at the camera start-up.
Note) “Repeated start condition” is not supported.
Sony Corporation
11

11 Page







PáginasTotal 18 Páginas
PDF Descargar[ Datasheet FCB-MA130.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
FCB-MA130USB 3.0 InterfaceInterTest
InterTest
FCB-MA13013 Mega Pixels Digital Camera ModuleSony
Sony

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar