|
|
PDF IZ1937 Data sheet ( Hoja de datos )
| Número de pieza | IZ1937 | |
| Descripción | White LED Step-Up Converter | |
| Fabricantes | Integral | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de IZ1937 (archivo pdf) en la parte inferior de esta página. Total 7 Páginas | ||
|
No Preview Available !
IZ1937
White LED Step-Up Converter
(Functional equvalent of LT1937 Linear Technology Corporation)
Description
The IZ1937 is a step-up DC/DC converter specifically designed to drive white LEDs with a
constant current. The device can drive two, three or four LEDs in series from a Li-Ion bat-
tery. Series connection of the LEDs provides identical LED currents resulting in uniform
brightness and eliminating the need for ballast resistors. The IZ1937 operates at 1.2MHz,
allowing the use of tiny external components. The output capacitor can be as small as
0.22uF, saving space and cost versus alternative solutions.
A low 95mV feedback voltage minimizes power loss in the current setting resistor for better
efficiency.
The device can used in mobile phones, PDAs, Handheld Computers, calculators, digital
cameras, MP3-players, GPS-receivers.
Features
• Internally determined LED current
• High Efficiency: 84% Typical
• Drives Up to 4 LEDs from a 3.2V Supply
• Drives Up to 6 LEDs from a 5V Supply
• 36V rugged bipolar switch
• Fast 1.2MHz switching frequency
• Uses tiny 1mm Tall Inductors
• Requires only 0.22uF output capacitor
ICs are available for shipment in chip form on unsawn wafers
Tab 1. Contact Pad Description
Contact pad number
Symbol
Description
01 SW Switch pad (Pin)
02
GND
Common pad (pin)
03 VIN Input supply pad (pin)
04
SHDN
Shutdown pad (pin)
05
GND
Common pad (pin)
06 FB Feedback pad (pin)
1 Ver.1.0/9.02.2008
IZ1937-TSe.doc
1 page  
Table 5 –Typical Electric Parameters
Symbol
Parameter, unit
ICL Output transistor current limit
UCESAT
ISHDN
Output transistor saturation
voltage
SHDN pad (pin) bias current
Testing mode
Typ.value
UIN = 3,0 V, U SHDN =
3,0 V
UIN = 3,0 V, U SHDN =
3,0 V, ISW = 250 мА
UIN = 3,0 V, U SHDN =
3,0 V
320
350
65
IZ1937
Unit
mA
mV
uA
OPERATION DESCRIPTION
The IZ1937 consist of following units: voltage switch on/off circuit, sawtooth generator, rectangular
pulse generator PWM –comparator RS-latch, error amplifier, output buffer, output switch, current-
limit circuit for output switch.
The IZ1937 uses a constant frequency, current mode control scheme to provide excellent line and
load regulation.
At the start of each oscillator cycle, signal from oscillator applied to S-pin of the RS-latch, the latch
output high level voltage is set. This voltage through buffer turns on the power switch (transistor
VT1). A voltage proportional to the switch current is added to a stabilizing sawtooth voltage and
the resulting sum is applied to the positive terminal of the PWM comparator A3. When this voltage
exceeds the level at the negative input of A3, the SR latch is reset turning off the power switch
VT1. The level at the negative input of A3 is set by the error amplifier A1, and is simply an
amplified version of the difference between the feedback voltage and the reference voltage of
95mV. In this way, the error amplifier A1 contols the peak current level to keep the output in
regulation. If the error amplifier’s output increases, more current is delivered to the output; if it
decreases, less current is delivered.
5 Ver.1.0/9.02.2008
IZ1937-TSe.doc
5 Page | ||
| Páginas | Total 7 Páginas | |
| PDF Descargar | [ Datasheet IZ1937.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| IZ1937 | White LED Step-Up Converter | Integral |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |